Teamhotrods

iTrader: (5)

Holy heck, he can use that battering ram to break through the EURO TRUCK clogs... I think he might be a little heavy up front!

Nerobro

iTrader: (2)

I watched a guy put something like 300g of weight on his truck..

bdmpastx

iTrader: (4)

The 4x4 was removed after the glue cured...I thought that was obvious

Teamhotrods

iTrader: (5)

TECH INSPECTION PLEASE!!

Rodarbal

iTrader: (49)

: Good luck at CORP this weekend! The 4x4 in the truck might be a bit more obvious on the carpet!

gigaplex

iTrader: (2)

It's not universally accepted to be a better car than the TT01E. The TT01E has a better reputation for durability, and the proposed solution of buying a TT02 then getting the truck body separately is also considerably more expensive, defeating both the affordability and durability objectives.

Pit-racer

iTrader: (4)

See you all at HobbyTown South Austin Texas this Sunday! Red Fury will be released!

bdmpastx

iTrader: (4)

I am going to try my best to get there after CORPs in Dallas.

Rodarbal

iTrader: (49)

I won't be able to race this one. But I should be there out later in the afternoon to hand off an iPad to Joe. Have fun, Pit! Get that thing broken in! I tell you, I never laughed so hard on the stand. They actually drive a lot better than I expected.

JatoTheRipper

iTrader: (11)

Good information! Thank you.

I put the Man TGS TT01E kit on my Christmas list. We'll see what happens.

TENCHO

my ESC didn't work for some reason... anyone have issues with the TBLE-02s ESC?

I have 2 of them and they both rapid flash red....and this was after a normal run one day, and the next day....flashing red.

manual says, check for damage.?

Nerobro

iTrader: (2)

You could try the programmign sequence again. Make sure they're set for brushed use.

Homer2207

I had one bad straight out of the box

Homer2207

Body mounting--- Myself and at least one other at our club have had "issues" keeping the cab attached to the lower body.... after a few "incidents" the supplied foam tape gives out. Have tried a few things haven't found the perfect solution yet I don't think....

Looking to see what others are using and if they have had this issue....

You know who you are..... no comments on the "incidents" LOL.....

Nerobro

iTrader: (2)

After my fourth race day (What's your truck? I'm Greg, I run the box blue colors..) my cab finally gave up.

Amusingly, most of the people running the euro trucks are experienced racers, and seem to have no problem whatsoever keeping their trucks intact.

I however... am a different story. For the race last sunday, I had stripped most of the white tape out and replaced it with black bolink servo tape. That, didn't seem to do as well. Tonights project, is going to be spreading a little e6000 in there, and through bolting the cab to the lower body. I plan on using six m3 nut and bolt sets, so that no individual screw will want to pull though. We'll see if that works on saturday.

I didn't have cab tape breakage issues until I put some weather stripping on my bumper, so I think that may relate to durabilty issues... eg: don't pad your bumper.