GuyIsDamGood

I'm finally going to put the TT-01 to the test.
It would be the Evo 5 versus the TT-01 (same batteries, tires and very similar electronics).

GuyIsDamGood

TT-01 Electronics
- Futaba MC330CR (ESC)
- Peak Dynasty (motor)
- Duratrax DTX 3600 Ni-MH (batteries)
- Futaba 3PM-X (radio)
- Futaba BLS451 servo

Tamiya EVO 5 Electronics
- Orion Vortex - KO Propo VFS-1 (ESC)
- Orion Vortex 10.5 (motor)
- Duratrax DTX 3600 Ni-MH (batteries)
- Futaba 3PM-X (radio)
- Futaba BLS451 servo

TT-01 best lap time 55.07
EVO 5 best lap time 50.75

-TT-01 and EVO 5 has the same tires

longuylander

iTrader: (7)

Are those electronics really that similar? One's a brushed (19t?) motor running on a vintage ESC and the other's a moderate brushless setup! Despite that, having that proportionally small time difference isn't too bad for the TT01.

Also... what track has lap times that high??

ThePanda

iTrader: (68)

swap the electronics and run the experiment again. That would really be interesting!

GuyIsDamGood

I don't have a real track in my area. So we race in a school yard(I.S. 296 - Bushwick - Brooklyn, N.Y).
I built a new layout. It had 6 Sweepers, 6 semi-short Straights and 6 Hairpins. I tried to learn the track with the 2 chassis as quick as possible.

gigaplex

iTrader: (2)

How large is this track that lap times are roughly a minute long?

GuyIsDamGood

I built the track to take up a little less than half of the school yard(Eldert St side). I modeled the track to flow along the red running area (X3). I had to learn the layout with the 2 chassis in less than 2 hours.

team green

iTrader: (14)

My spec racers

sgtlt

iTrader: (5)

Just ordered one of these trucks, should a lot of fun.

b20btec

iTrader: (11)

What packs are you guys running on the team hahn? I'm looking for the largest capacity that will fit.

KA2AEV

iTrader: (1)

Are just the bodies available yet???

littlehonda14

iTrader: (60)

I just ordered me a truck the other day cant wait for it to get here

Badmojoh

We have decided to start a box stock (except for aluminum center shaft and bearings) MAN truck series up here, just wondering if anyone has any build/balance advice? Grease weights in f/r diffs? dry gearbox or lubricated? Weight distribution? Anything helpful with the pogo shocks?

GuyIsDamGood

Is there any factory or aftermarket Sealed Gear-Diff for the TT-01?

vivo quevas

iTrader: (19)

oLook great love the colors of your trucks. I was in Stockton over the weekend they had 5 trucks racing I didn't bring mine but this weekend I will race it.

+ https://youtu.be/msy44eh9uL0" title="View this video at YouTube in a new window or tab" target="_blank">YouTube Video