Sanyo 3000H problem??
10-28-2002, 07:41 AM
#1
Sanyo 3000H problem??
I have problem with my 3000H match pack from Integy! SOme how it keep falt peek and will not get charge at all.... Then I try to discharge it with my Turbo35Bl is just have no juice in the batts...
What should I do? I was thinking about getting a discharge tray from Intege and equilze it?? will this help? or may be dead short it? (How do dead shrt.?? I never done it befor)
If it's really bad...i like to use it as my practice pack..but..oh..well..
Or...better yet just thrown it out?
Please help!
What should I do? I was thinking about getting a discharge tray from Intege and equilze it?? will this help? or may be dead short it? (How do dead shrt.?? I never done it befor)
If it's really bad...i like to use it as my practice pack..but..oh..well..
Or...better yet just thrown it out?
Please help!
10-28-2002, 02:34 PM
#2
It sounds to me as if you have a bad cell in your pack. You should cycle one cell at a time to identify the bad cell and then replace it. If it's only a practice pack I wouldn't worry too much about matching the new cell to the pack. Just get any 3000H.
10-28-2002, 07:28 PM
#3
I never cycle single cell b4...what kind of setup do I need for my turbo35Bl to cycle single cell?? What # should I get to show that my cell is good or bad??
This is acutally my good racing pack...but...I think I'm going to use it for practice or for my Nitro starter box. Going to get new 3300 pack soon.
This is acutally my good racing pack...but...I think I'm going to use it for practice or for my Nitro starter box. Going to get new 3300 pack soon.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
