Tamiya TRF418
#1115
Oddly enough I saw a Barracuda at racing tonight... blast from the past!
#1117
Nice Redbull throw back Thursday masterhit...brings back memories of the fish, complete with splifferential My evo3 was made for me. Can't wait for the evo6.
#1119
Tech Master
You can just fit the older spool cups or get the steel ones that require no blades (like on the 417v5) the spool is the same as the 417 in fitting so any 417/418 steel spool outdrives should fit.
#1120
Tech Elite
iTrader: (24)
And/or try some ARC blades... But they are a real tight fit. You need pliers to push them on over the pins.
Last edited by 2-Bad; 05-30-2014 at 06:51 PM.
#1121
I don't bother with blades when using a spool. I use the Smokem spool cups and they last forever in mod. Since they don't need blades, I don't have to worry about blades breaking mid-run either.
#1122
Tamiya has steel spool cups that don't require blades
#1123
Just tried Jilles setup at the Tamiya track. It is LEGIT
#1125
Tech Master
http://www.thercracer.com/2014/05/ji...dy-set-up.html