Mwdynamics

Hi all,

Put my lrp Sxx tc v2 in my t4 today. It is starting and stopping very quickly. Can't even use it. I've checked the manual and its next to useless!
Has anyone had any experience with them?
Do I need to plug it into a lrp interface into the laptop and reset it? Or is there a process of pressing buttons I can do?
I have a 15.5t sensors motor in it so that's not a problem.
Any help would be great on this matter! It's very frustrating!

Thanks in advance all

Troy Carter

iTrader: (22)

What is it doing?

Mwdynamics

It's accelerating then stopping quickly repeating. So start stop start stop constantly when everything in tx is turned on

tc1

iTrader: (15)

Sounds like its set wrong, Set all your endpoints on the radio to 100 and re-calibrate it to the radio. If that doesn't do it, the manual has a procedure for doing a reset of all adjustments. Hope it helps!!

Travis

Mwdynamics

Thanks travis,
I've followed the manual for the radio/speed controller setup and still having the same issues. I don't know what else to do apart from purchasing a USB interface and going through the settings on the laptop. Would that be the next step? I've never used the USB interface before

Troy Carter

iTrader: (22)

The USB interface won't help you. It' pretty much only allows you to load different firmware on the ESC. It might solve your issue by reloading the firmware but I seriously doubt that. I think you must have bigger issues with the ESC or your radio.

Mwdynamics

Ok Troy, thanks for that. I may get a USB and reload the firmware. I've tried resetting the min max on throttle so hopefully that will work

Mwdynamics

Turns out that I have a nackered board. Off for a upgrade now! :-(