uranghanyar

FYI ; if you change diff pulley to 37t it means your car is TRF 417 in pink coz the belt re the same and make internal ratio same 1.94

kanamin

Can someone post a pic of a mounted motor? Trying to understand that motor mount. Is it just diagonal compared to the zero S?

Yogi-

I just used the motor holes that sat I at the lowest point.

Yogi-

Zero spool,zero alloy spur holder and zero diff all fit nicely.

drdanke

Is there an ETA on replacement suspension arms for the XI Sport? I want to buy 2 kits to run here, and I always keep replacement arms in stock for those bad side hits.

Yogi-

My intention is to buy a second kit for parts. Handy having extra diff,spur gear holders etc,as well as all the arms,hubs,steering parts and screws you need.

Yogi-

Sorry bout the flash.

kanamin

I see, cheers!

So it just doesn't use holes opposite each other on the motor, but one in? (6 holes so 120 degrees apart?)

I was looking at the TOP Photon EX trying to figure that one out and it uses two ADJACENT holes, which just seems wrong to me, I like this better.

site won't let me post urls yet, but I just googled top photon ex motor mount

Yogi-

Correct just use the two holes you can get at.

There is a motor mount still to come out that will use the opposite hole but I think this one will be fine.

kanamin

But that was the problem with the Zero S.

I just noticed the yokomo BD7 uses a similar mounting (or maybe one tucked behind the spur as well like the new one you posted, can't tell)

Cadman1981

iTrader: (1)

This one is available at TQracing



http://www.tqrcracing.com/shop/produ....asp?p_id=4864

Yogi-

This one may not fit the xi sport.

6376vette

It should fit.

Cadman1981

iTrader: (1)

but it's for the 3Racing Sakura XI

Aluminum Motor Mount - Ver. 2 For 3racing Sakura XI

Yogi-

The xi sport is a cheap version of the new soon to be released ultimate ?
The arms,hubs,nuckles,steering,bulkheads, all new and I'd assume the motor mount ( I might have one and ill check ) might be new to.