R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Electric On-Road (https://www.rctech.net/forum/electric-road-2/)
-   -   Speed Passion F1 car - The SP1 (https://www.rctech.net/forum/electric-road/712987-speed-passion-f1-car-sp1.html)

Sonter 11-18-2013 11:48 AM


Originally Posted by Ph3nyx (Post 12735910)
it's a known issue with the ride , you'll have to use CA right out of the box before the 1rst run (and a good one).
i'll prefere by far using pit shimizu 571/572 or 574/575 for carpet.

I race on asphalt.... do you suggest any other brand instead of ride ?

InspGadgt 11-18-2013 11:53 AM

I found the Ride tires had too much push. I'm running the Pit Shimizu 574 fronts and 572 rears.

Sonter 11-18-2013 11:57 AM

are these soft enough compaired to ride super soft ?

can someone PM me where can I purchase a set pre mounted ?

InspGadgt 11-18-2013 12:22 PM

Some people are running the Rides in the rear with the Pit Shimizu in the front. The most common Shimizu combination is 572/571 but on our track I needed a bit more front grip so I went with 574/571. When I ran Rides I ran the hard tire in the rear and the soft up front and it still pushed badly.

With rubber tires softer isn't always going to give you more grip. A lot depends on the heat of the track you run on. Very hot tracks are better with a harder tire because soft tires get greasy when they overheat.

Sonter 11-18-2013 12:29 PM

any suggestions where to get these tires please ?

Ph3nyx 11-18-2013 01:02 PM

they are not pre monted , but you can found it on rcmart at a reasonable price.

Solara 11-18-2013 01:31 PM

And make sure when you see Pit's tires and they called it out "SOFT"...it is not the tire compound soft, they are describing the SIDE WALL "SOFT"....

For carpet definitely 571/572 combo...that is equivalent to Tamiya TCS F/R tires...and when using Pit's tire, you must also purchase the Tamiya FOAM TIRES rims....regular rims with rib you have to grind them off and need some modify work.

http://www.tqrcracing.com/shop/produ....asp?p_id=1650

http://www.tqrcracing.com/shop/produ....asp?p_id=1988

http://www.tqrcracing.com/shop/produ...w.asp?p_id=302

Sonter 11-18-2013 01:53 PM

Is this combination good for asfalt ? 571 fronts and 572 rears? Usually at my club they run ride supet soft both front and rear.

InspGadgt 11-18-2013 02:20 PM

That depends on the track...not all asphalt tracks are going to have the same grip. I tried it on our track and the 571/572 combo worked fine. I like the 574/572 combo better on our asphalt track though as it gives me a little more steering than the 571/572 combo. If your track runs all super soft though you may need a softer rear so you might want to use the 575 or 579 rears with the 571 or 574 fronts.

Besercoe 11-19-2013 02:38 AM


Originally Posted by Sonter (Post 12735640)
I was hit by an ARC Formula 1 car. Maybe an SUV wouldn't have made that damage on my SP-1 :ha::ha:

I have PM you back!!

ARC formula 1 car?

Sonter 11-19-2013 04:04 AM


Originally Posted by Besercoe (Post 12738040)
ARC formula 1 car?

By mistake I wrote formula 1... It was a touring car!

Ian_R 11-21-2013 05:59 AM

I've just received my carbon battery holder plate. Anyone got any idea what the two 10mm grub screws that are in the packet are for?

nrtv20 11-21-2013 06:29 AM


Originally Posted by Ian_R (Post 12744729)
I've just received my carbon battery holder plate. Anyone got any idea what the two 10mm grub screws that are in the packet are for?

Replace the button head screws for the spring mounts

Ian_R 11-21-2013 09:12 AM

Thank you

metalnut 11-22-2013 01:06 AM

http://www.redrc.net/wp-content/uplo...sF1Inserts.jpg

Just saw these announced. Not sure they're really needed, but they look pretty sweet and it looks like they could fit the SP-1.


All times are GMT -7. It is currently 08:36 PM.

Powered By: vBulletin v3.9.3.6
Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.