krits

iTrader: (8)

Very Nice. what is the model number of the wheels and tires?

MikeGozz

iTrader: (17)

Wheels- http://www.hpiracing.com/en/part/3037

I don't know what the tires are but HPI does still make the #4590 slicks listed on this page (although it looks like he is running foams)- http://www.hpiracing.com/en/parts/112715/wheels-tyres

Mike

fkmliu

iTrader: (2)

Not yet, but will post it later, the diffuser also act as a skip plate. buy the diffuser Team Associated Pro Rally Rear Diffuser Set 7172, I got mine from Tower Hobbies, take out the 4 screw from the rear drive housing , measure the hole from the WR8 chassis, re-drill 4 hole on the diffuser, sand down the original countersink to make it flat on the back side of the diffuser, bolt it onto the bottom rear of the chassis, that's it. you might need to trim the diffuser a little to make it fit inside the body.

fkmliu

iTrader: (2)

yes, that's the wheel I'm using on the pictures & the tire is the HPI4590 http://www.hpiracing.com/en/part/4590

MikeGozz

iTrader: (17)

Sweet, seems simple enough. Maybe I'll give it a try.

Those are the rims but what tires are you using? They look like foams?

fkmliu

iTrader: (2)

sorry about that, i'm using this http://www.hpiracing.com/en/part/4590

fkmliu

iTrader: (2)

I also using
this http://www.hpiracing.com/en/part/107976 to run on the indoor clay track
https://plus.google.com/photos/11137...35497050056367

fkmliu

iTrader: (2)

Here are some pictures for the mod

1.http://picasaweb.google.com/11137773...66132988055154
2.http://picasaweb.google.com/11137773...66002201431682
3.http://picasaweb.google.com/11137773...66359428098066

Rc1987

Hello just bought wr8 flux 2013
Was just wondering what top speed has anyone got from one /controllable speed/
Just out of interest?

fkmliu

iTrader: (2)

I believe the stock setup can run up to 60mph with 3s lipo.

MikeGozz

iTrader: (17)

I've got some speed out of mine ;-) http://youtu.be/ppucX2qEYS0

I don't have GPS or any of that flippity flappity but it's pretty quick.

RC Passion

iTrader: (8)

Two thumbs up!!!

MikeGozz

iTrader: (17)

All your bodies are amazing! Nice job!

MikeGozz

iTrader: (17)

Looks like HPI is finally producing a Subaru body for the WR8!!

http://www.hpiracing.com/en/part/113239 & http://www.hpiracing.com/en/part/113240

They look great!




I'm looking for somewhere to order a few of them. I can't wait!

MikeGozz

iTrader: (17)

Alright! Someone finally listened and produced a set of CVDs for the WR8!

http://integy.com.cn/st_prod.html



They look about the same as the RCDamper set for the Bullet, hopefully they are made out of the same type of steel too. I'm going to order a set as soon as they show up at tower or eBay so I can take advantage of the discounts.