need help about "stalled" problem
#1
need help about "stalled" problem
i just got tenshock 401 4000kv about 1 week ago, and recently it appeared got stalled sometimes whenever i quickly punch hard the throtle, i have this problem too with xerun motor before
my tenshock 401 4000kv got paired with 1/5 - 1/8 HKU 120A esc and using HKU 5A 5V UBEC
and a short while ago, when i punch the throttle hard i got stall effect but like stuttering and suddenly the red wire from the UBEC got snapped from the ESC when i ran full throttle, and just beforte that, i just burnout my wheels like crazy and drifting all the way in concrete road
could be the UBEC wire got hot and got snapped from the esc because i burned out my wheels earlier(too much amperage draw)?
i soldered the UBEC in pararel, which is connected directly to the battery (in ESC but directly to battery)
my tenshock 401 4000kv got paired with 1/5 - 1/8 HKU 120A esc and using HKU 5A 5V UBEC
and a short while ago, when i punch the throttle hard i got stall effect but like stuttering and suddenly the red wire from the UBEC got snapped from the ESC when i ran full throttle, and just beforte that, i just burnout my wheels like crazy and drifting all the way in concrete road
could be the UBEC wire got hot and got snapped from the esc because i burned out my wheels earlier(too much amperage draw)?
i soldered the UBEC in pararel, which is connected directly to the battery (in ESC but directly to battery)
Last edited by j3fron; 12-14-2012 at 01:49 AM.
#2
bump.