RedBullFiXX

iTrader: (34)

Short arms have -1.5 marking
http://www.teamyokomo.com/partslist/...s_b7_sacr.html

bertottius

iTrader: (27)

Thanks

Rodney Racer

iTrader: (1)

Try this.

mikeygar

iTrader: (14)

thank you for this! Been looking for a chart since the 16' came out!

mac853

Dear anyone:

In fact i want using bd7 2013 to run, but that car is rebuilt from parts, then there has no battery mount(b7 118g), could anyone tell me if i can replace it by similar of other cars?

And other thing, in fact this car would run 2015/2016 chassis' black steering linkage.
Could anyone tell if has difference with same part from different version chassis?

Best regards

tiny tom

TECHRA blocks

Anyone used this on carpet yer? Just got them and scratching my head where to start

rhodopsine

If you go on Techra Facebook page, someone posted a chart with measurements for all inserts. I guess that from there, you can set it close to the position of regular Yokomo blocks and go from there.

Martin Paradis

mac853

Dear anyone:

Somebody have got the chart of length of different inserts of Samix block?

Thank you!

zaraz

iTrader: (38)

I have searched for a MR Roche floating servo mount and cannot find one, if some one can point me in the correct direction, radtech has one but they are different, please help thanks

DirkW

iTrader: (1)

EDIT: ... sorry, no idea about MR Roche, just Spec R

tiny tom

Cheers, make life easier, got the bass ones to add weight onto the car

Damon

http://site.petitrc.com/reglages/yok..._TechraMounts/

mac853

Could somebody tell me if i want to run my bd7 with 20t center pulley with 34t spool pulley and gear diff, can use belts of bd7 2016 car or can cause too tight?

Thanks!

rhodopsine

Ha! That's even better!

mac853

Could anyone tell me if is doable if remove upper deck post of bd7 2013 car?

Would affect the car or even damage it since motor mount has less screw?

Since i want to run bigger pinion.

Thanks