Translation needed from Yokomo R12 manual
#1
Translation needed from Yokomo R12 manual
Normally I would post this in the R12 thread, but I didn't want to limit it to the 1-2 people on the forum that care about the car....
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
#3
Normally I would post this in the R12 thread, but I didn't want to limit it to the 1-2 people on the forum that care about the car....
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
The translation is: do not use the 0.5mm part.
This must be because on the basic setup the 0mm part is used.
#4
Tech Initiate
Normally I would post this in the R12 thread, but I didn't want to limit it to the 1-2 people on the forum that care about the car....
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
I have resurrected my R12 again and have always been curious what the following included option part changed. The manual won't let me grab the text and run it through a translator.
I'm guessing it either moves the pin up or down by .5mm, or moves the pin in or out changing arm length.
Thanks in advance, it is greatly appreciated. Next step was to pull the parts off the car and put both up on the comparator.
Mike Slaughter
http://www.rc-race-and-drift-japan.com/r12/index.htm
ML