NVisible

iTrader: (1)

Nope. Never been down there for a race. I may pop down to fastcats sometime though

MrRolla

iTrader: (30)

Guys,

I have a problem with the rear suspension, in particular the aluminium nut for the pivot pin (302032). The problem is i have i that is completely round but i dont have a completely round holder (302040) for it there for i cant fit the aluminium nut in the holder...

It is late here and i am tired so please tell me its something stupid i have overlooked or have I been given a wrong part??

Please help a fellow Xray Fan get his kit built

RIDDLER

it is supposed to be flat on one side. you may have been sent a wrong part.

contact your LHS they might have some in stock. it really doesnt cost much.

MrRolla

iTrader: (30)

Its not the point you spend $595 (AUD) on a kit you expect it to go together.... hmm

So it looks like im not going mad then???

theisgroup

iTrader: (10)

i have never seen a round one. and I have had every kit up to this one. If they do not have one, you can purchase the one piece one from the t1r\evo2 and cut it in half.

shoot a pic, maybe it's the wrong piece

MartynD

My guess... it will go together once you have had some sleep..

For me... I cannot complete my car because of one 5x1 o-ring.. Kit came with 3, instead of 4. Store I bought the kit isn't open again until Tuesday.. and even then.. I hope they have the part...

MrRolla

iTrader: (30)

Nah its definetley not going to go in the holder as its cmpletley round and doesnt have the flat bit on the bottom....

what a pain in the ass seriously

MartynD

Did the other 3 go together ok?

mtveten

iTrader: (29)

Anyone know where I can mail order a euro version the fk05? The 1-way is somewhat required for the asphalt season.

Mark

theisgroup

iTrader: (10)

hey guys,

someone asked about an fk05 used for sale? Funny thing. There is one on the for sale forum right now

big_G

Try here in Holland

pete68

iTrader: (1)

hi what is your opinion about the new fk05 handling speed steering etc etc!!
Pete68

rctoyguy

iTrader: (21)

It handles great - rubber tire on asphalt, out of the box, very smooth. I made a small spring change from the setup sheet, and it was on rails - at least on our parking lot track, which was set up as a very fast, open layout this weekend.

I'll just say that it made me look like a much better driver than I actually am.

MrRolla

iTrader: (30)

yeah they went together great because they arent round the have the flat bit on the bottom

rayhuang

iTrader: (5)

Please excuse me if I am not following this right-but I think with a file or dremel-can you not put the flat on the insert so it will fit? The parts is junk anyways-so if you bugger it up-who cares?