Robi dyno software-help
#2
From the robi site.... www.robitronic.com
But, its semi free.....it will work, but a lot of the features do not work until you buy a license fee....
Later EddieO
But, its semi free.....it will work, but a lot of the features do not work until you buy a license fee....
Later EddieO
#3
while we're on the subject....
in the full version, is there any way to display a table of data that is time based? the default tables are defined by torque or current steps, and time is just an auxiliary column. can we configure the table in any way to represent time steps, with resolution to the .01 sec?
thanks.
in the full version, is there any way to display a table of data that is time based? the default tables are defined by torque or current steps, and time is just an auxiliary column. can we configure the table in any way to represent time steps, with resolution to the .01 sec?
thanks.
#4
Ray- I downloaded both ver 2.0 and 2.4, we can try them tonight at the track, i put them on disk, so i hope they work...and Chris- Are we bringing the dyno to the race in Columbus?
-Buddy
-Buddy
#6
Team Balls Manager...Become a "Balliever"
by the way, i owe you 4 dollars. it's like the honesty policy. you didn't notice, but i looked four times last practice... oops!
what's the status on the apparel?
perhaps the robi will make it south. it depends what we get done tonight.
- henry
#7
HAHA, thats good, im running low on cash see you tonight
-Buddy
-Buddy