R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Electric On-Road

Reply
 
Thread Tools Search this Thread
Old 12-28-2004, 05:48 PM   #1
Tech Addict
 
t4usee's Avatar
 
Join Date: Nov 2004
Posts: 505
Trader Rating: 5 (100%+)
Default amp draw question

When you break in brush's the proper voltage should be 2-3 volts. There is a amp reading, what range should the amp draw be? Do you want high amps or low? Would I be wrong to say if the motor is pulling low amps at 3 volts it would be better or less friction in the bushings. What if you run the voltage up to 7 volts, do you want high amp reading or low?
Thanks for any reply's
t4usee is offline   Reply With Quote
Old 12-28-2004, 06:10 PM   #2
Tech Elite
 
EddieO's Avatar
R/C Tech Charter Subscriber
 
Join Date: Oct 2003
Posts: 3,414
Trader Rating: 6 (100%+)
Default

No load amp draw really means nothing......I never pay attention to it unless its very high, which is typically caused by something not being right with the motor.

On the average monster, you will see from 5 amps to 10 amps at 3 volts....just depends.

But like I said, it really doesn't mean much....

Later EddieO
__________________
www.teambrood.com
EddieO is offline   Reply With Quote
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
Question: Mini T's stock setup amp draw???? geminiracer R/C Tech Site Forum 0 01-07-2006 08:01 PM
plug amp draw question? nitrothugg Nitro On-Road 0 12-13-2005 03:40 PM
amp draw? odawg315 Electric On-Road 21 07-04-2005 06:18 PM
Question about amp draw between cars cartmen34 Electric On-Road 13 06-16-2004 02:23 PM



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



All times are GMT -7. It is currently 06:26 PM.


Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net