Exotek F1R
#2626
Tech Champion
iTrader: (15)
trying to get the rear of my F1 R3 to go higher I have the front at five and a half I need to raise the rear of the car the plastic inserts won't get me any higher than 4 and 1/2 is there any other option parts to where I can get the rear of the car to at least five mm or even five and a half run on a bumpy asphalt track rubber tire thanks
#2627
Gravity rc is our track tire. Measuring from the corners of the rear pod in the back and at the side Springs and on the front just under the droop screws by the front knuckles
#2628
#2629
Quick question, do the X-ray gear dif fits in this car? Thanks in advance
#2631
#2632
Has that happen to anyone else ? It’s never done that with my touring cars
#2634
okay thank you.same tires just new ones. Never notice it before.
#2635
Front suspension and chassis
Does anyone know when the new front suspension will be released plus if there is a new chassis in the pipe line
#2636
I think it might be a secret shhhhhhh. LOL
Last edited by 5th wheel; 11-30-2018 at 05:54 PM.
#2640
Tech Addict
iTrader: (19)
Hello fellow racers. I have been struggling with the F1R3 steering rack system for the IFS over the past few months. The system will not center itself after turning left and right. If I turn left the system tends to deviate the wheels towards the left and likewise if I turn to the right. I have changed servos, use a servo horn instead of a servo saver, disassemble the entire system and rebuilt it per the manual, tried to shim out all the slop and nothing seems to fix the problem. I do not want to go back to the stock steering assembly using the Y shaped servo posts. However, if I am not able to resolve the problem that may be my only option. Any help or suggestions you can provide would be appreciated. I am also going to post this on RC tech to see if anyone has had a similar problem and maybe able to help. Thanks in advance.