Xray T3 2012
#2405
Tech Adept
17.5 Blinky gearing
Hi,
I run the xray t3 12 mainly on mid sized carpet tracks. Ive always run 13.5 boosted and am now switching over to 17.5 blinky. Roughly how many teeth in pinions do i need to go up by in comparison, any ideas?
I run the xray t3 12 mainly on mid sized carpet tracks. Ive always run 13.5 boosted and am now switching over to 17.5 blinky. Roughly how many teeth in pinions do i need to go up by in comparison, any ideas?
#2407
Tech Apprentice
#2409
rear toe in issue
guys, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3... the car is brand new of course....
#2410
Tech Elite
iTrader: (49)
guys, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3... the car is brand new of course....
#2411
#2412
Tech Initiate
guys, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3... the car is brand new of course....
#2414
#2415
I find 1.75mm of shims on the left, and 1.5mm shims on the right gives equal toe in of 3 degrees. Not sure why.
Using the one peice holder at the front of the rear will reduce rear flex and traction