Xray T3 2012
#2347
#2348
Sorry in advance if this has been asked, Just building a 2012, will the body mount holes from my 2011 fit so I can re-use the bodies? I am just about to order some other parts, and dont want to build the car until the parts arrive, but want to know if I need to order a new body.
Also, has anyone fitted the third body post at the front?
Also, has anyone fitted the third body post at the front?
#2350
#2351
Tech Master
iTrader: (29)
Do you have the '12 front tower there? Not sure if there is enough cf area to mount the post cleanly? You may be able to mount it on the lower section though? I'll have a look later today if you don't have one handy.
I have a VBC front tower that has holes for the centre post.
IMG_0026 by silvalis, on Flickr
VBC
T3'12
T3'11
It looks like it's possible to drill the holes, but you'll be doing semi-circle cuts above and below the centre hole in the '12 tower. Not sure how secure that will be. Maybe mount a plate behind it?
I have a VBC front tower that has holes for the centre post.
IMG_0026 by silvalis, on Flickr
VBC
T3'12
T3'11
It looks like it's possible to drill the holes, but you'll be doing semi-circle cuts above and below the centre hole in the '12 tower. Not sure how secure that will be. Maybe mount a plate behind it?
Last edited by silvalis; 05-01-2012 at 01:10 AM.
#2352
Sorry in advance if this has been asked, Just building a 2012, will the body mount holes from my 2011 fit so I can re-use the bodies? I am just about to order some other parts, and dont want to build the car until the parts arrive, but want to know if I need to order a new body.
Also, has anyone fitted the third body post at the front?
Also, has anyone fitted the third body post at the front?
#2353
Anyone have tested new composite arms? What is the difference between new arms and "old" original arms?
#2354
does the exotek chassis part# exo1105 work with the t3 2012
#2355
Tech Elite
iTrader: (98)
[QUOTE=theatriks;10676099]does the exotek chassis part# exo1105 work with the t3 2012[/QUOTE
it would work but you will be going back to the old t3 t311 servo setup...
i have 2 of em...as well as a used smokem
i also have a new genuine t311 chassis just sitting around also....
no need for them now as i have the vbc conversion kit
it would work but you will be going back to the old t3 t311 servo setup...
i have 2 of em...as well as a used smokem
i also have a new genuine t311 chassis just sitting around also....
no need for them now as i have the vbc conversion kit