Xray T3 2012
#2116

I can't find it anywhere at the moment. I have it on my PC but it is 1 MB large (and forum limit is 488 KB) so I can't upload it. I did found this picture however, hope it helps http://www.rctech.net/forum/xray-aus...l#post10411659
About the rear belt... I put mine in the loosest position and straight from the beginning the belt started to wear much on it's side. It snapped after 15-20 batteries (10,5T boosted) . I will put the next one in the middle position.
About the rear belt... I put mine in the loosest position and straight from the beginning the belt started to wear much on it's side. It snapped after 15-20 batteries (10,5T boosted) . I will put the next one in the middle position.
#2118
Tech Adept
#2120
#2121

ARENA released Titanium Coated Suspension Arm Pin & Shock Shaft
#2122

anyone here running mod having issues with the rear belt snapping ....i got mine one notch down from the loosest notch....and its snapping on me.....im running a 3.5 turn (no boost no timing)
#2123

It seems most of us thinking the belt is too tight eventually get them snapped...
#2124
Tech Master
iTrader: (19)

The belts stretch after a couple weeks of running in any class. I left mine in the center notch and the loosened up and then i tightened it 1 notch, its not to tight or to loose now, i ran 4.5 with boost on saturday on very high grip asphalt, no skipping or slipping of any kind.

#2125

I've always been instructed to run the belt tighter for mod wind motors because they will skip and fail, especially under braking. Although I'm waiting for my t3'12 I've never had an issue with my other X-rays when running the rear belt on the tight side.
#2128

Where could someone find a new 2012 T3 in stock? Preferably in the US.
#2130