Speedmerchant REV 6 build question....HELP?
#1
Speedmerchant REV 6 build question....HELP?
I just got around to installing the carbon fiber link set conversion for my REV 6.
But the original pivot balls (threaded) do not fit in between the machined pivot sockets. Too big, major gap.
Any ideas? Or do I need to use different pivot balls from Speedmerchant?
Thanks for any input.
Greg G
But the original pivot balls (threaded) do not fit in between the machined pivot sockets. Too big, major gap.
Any ideas? Or do I need to use different pivot balls from Speedmerchant?
Thanks for any input.
Greg G
#2
Same exact pivots and threaded balls as used in the center pivot.
The gap really does not matter as long as there is no play between the link and the ball. They should rock side to side freely. You adjust the 2-56 screws in small increments.
The gap really does not matter as long as there is no play between the link and the ball. They should rock side to side freely. You adjust the 2-56 screws in small increments.