com lat
i just bought a twister com lat. does any one know the right height for the diamond bit. the way that it was set up when i bought it had two gold washers and a thin plastic piece under the bit and when i try to cut the com it hacks up the com so if any one could help me that would be great thanks
|
do you mean a comm lathe?
|
yes
|
Sounds like your bit is either too high or too low. You want the bit to contact the comm at it's center or just a touch higher. You space the bit higher or lower with shims. If you didnt recieve any just use thin sheets of metal. It normally takes a little while to get it right. |
Sounds like that bit is toast too.
|
All times are GMT -7. It is currently 08:37 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.