Motor-Run In Question
#1
Motor-Run In Question
This is a stupid question, but i was motor-running in my motors, and i couldnt help but forget the AMPs and Volts were good. Say if i ran my motors at 7.0 on my Turbo GFX what are good AMps and Voltages? Is it better if the motor has higher amps and volts or lower? Sorry for the stupid question.
#2
Guest
I run in my motors using the Motor Master - Surikarn Version on pulse mode 2V and 3V for 300 sec.
Bryan
Bryan
#4
Guest
Nice to see you here Dave ! Any difference in using setting #5 other than longer pulse in #4 ? Any significant benefit ?
Bryan
Bryan
#7
Tech Master
Re: Motor-Run In Question
Originally posted by JDXray
This is a stupid question, but i was motor-running in my motors, and i couldnt help but forget the AMPs and Volts were good. Say if i ran my motors at 7.0 on my Turbo GFX what are good AMps and Voltages? Is it better if the motor has higher amps and volts or lower? Sorry for the stupid question.
This is a stupid question, but i was motor-running in my motors, and i couldnt help but forget the AMPs and Volts were good. Say if i ran my motors at 7.0 on my Turbo GFX what are good AMps and Voltages? Is it better if the motor has higher amps and volts or lower? Sorry for the stupid question.
if you have a stock motor then normally i would go with the lowest amps and highest effciancy.
the reason for the lowest amps is because in stock motors you have bushes and these could be well centered or not.
if they are not this means amps will be high.
in general higher amps could be a shorting arm, high degree of timing,bad bearings,double mags,aligment of brushes so as you see theres a whole list of things.
obviously in mod higher degree of timing will give more power but increase in motor amp draw,like wise bad bearing will give you high amp draw but will negatively effect the motors performance.
#8
Re: Motor-Run In Question
Originally posted by JDXray
if i ran my motors at 7.0 on my Turbo GFX what are good AMps and Voltages? Is it better if the motor has higher amps and volts or lower? Sorry for the stupid question.
if i ran my motors at 7.0 on my Turbo GFX what are good AMps and Voltages? Is it better if the motor has higher amps and volts or lower? Sorry for the stupid question.
#9
okay i run stock motors mostly besides one 19t epic binary. I usually motor run-in at 3.0, 5.0 and 7.0 volts(i guess its volts or amps) I like to run my motors at different settings. Is that bad?
and when there running i usally get around 4.0 avg amps (drawn i guess) and 7.0 volts avg.
and when there running i usally get around 4.0 avg amps (drawn i guess) and 7.0 volts avg.