capacitor/ schottky diode
hey folks....
please help me on choosing a power capacitor and shottky diodes for my motor.... I'm planing to install a 10000uF cap, but I don't know what voltage rate the cap must be (10V??? 16V??? ).... About the schottky.....I read on Novak website that the minimum rate is 35V/8A.....but most drivers use 3amps (40 volts) at the track where I use to run.....:confused: :confused: |
im not sure about hte schottky but for the cap 10 - 16 v is fine, just dont go below the batt voltage
read more from the "power capacitor to gain acceleration" thread in this forum i think its on the 2nd page |
|
All times are GMT -7. It is currently 07:13 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.