jdeadman

iTrader: (41)

Mine is 570g with No battery holders/Velcro with the vertical motor mount installed. No Wheels or tires and no Electronics

I'm going to start installing the electronics and I'll get a base weight in a bit

thefan

iTrader: (3)

Does anyone know whether any other rear suspension mount will fit the zero i want to run 2.5deg rear toe without having to change both mounts in case i want to switch back to 3deg

Odin544

iTrader: (93)

Just buy the RF -.5* and the pivot balls. Use the stock RR plastic 3.0*. With both of those you'd end up with 2.5*.

thefan

iTrader: (3)

Ok thanks i was under the impression it was +.5deg and then had to swap out the 3deg for the 2 to end up with 2.5

seaball

iTrader: (9)

for anyone looking for a collection of gear diffs ... (like that's real common ) ...

check here.

matt*strike

iTrader: (41)

Hey guys just need a starting point for the gear ratio in 17.5 blinky

jdeadman

iTrader: (41)

on a tight track I'm running 93/41 with muchmoore 32's

SteveM

iTrader: (165)

Indoors on carpet with a medium sized track I use an FDR of 4.0 to 4.2

kikoy

iTrader: (2)

Hi guys!

What shock oil will be a g good starting point for asphalt medium grip track?

Thank you in advance!

6376vette

Depends on how bumpy the track is but I would start with 40.

jdeadman

iTrader: (41)

OK Sakura fans. Just got mine Ready to run and Body painted and I'm sitting at 1398g. That's as light as I can make it.

I am balanced with a fairly light 2s 5000mah pack. I have some room to move a lighter battery out on the chassis before it hangs off of this wide (female dog)

What is everyone else running for batteries and what is the weight difference from the Stock Wide Plastic chassis compared to the narrow Carbon fiber chassis?

Thanks

matt*strike

iTrader: (41)

I just received my sakura zero s and I must say WHY 3racing did you use phillips instead of hex. Started to put the diffs together and I grabbed a screw and to my surprize was a phillps NOOOOOOOOO!!!! I couldn't believe it. I hate kits with phillips. This is the 21st century and everyone knows small phillips strip worse than hex. I wish I had a giant screw kit so I could change them all out. Oh well ill report later on how the phillips are going.

FauxMako

The Diffs and the spur gear holder are the only phillips screws. I believe if you search through the thread you can find someone supplied a link or specs for hex screws for those locations.

rc-goods

Zero Force Sakura Bearing Kit Set (12pcs) (ZF-E13002)



www.rcgoods.com

matt*strike

iTrader: (41)

Do I flip my diffs to get the verticle motor mount in or what I couldn't figure it out so I gave up and put the stock one in.