2LikesXray T3 2011
10-20-2010, 05:41 PM
#526
If there's still too much rebound you can bleed the shocks by unscrewing the bottom cap and then slowly push the shock shaft in again. This should get rid of a bit of excess oil.
Jonny
10-20-2010, 06:00 PM
#527
Tech Rookie
Cheers, Ive spent some serious hours to night getting them right.
In the end I drilled a 1.2mm hole in the top. Remove the foam. Fill shock all the way with 350 oil with 3 hole pistons. Leave the shaft all the way out and put the cap on. Then just spent ages bleeding them.
Got them to about 10% rebound which I think will be a nice feel. I swear my 009 alloy shocks weren't this hard. My photon is done in 30mins with 10%.
In the end I drilled a 1.2mm hole in the top. Remove the foam. Fill shock all the way with 350 oil with 3 hole pistons. Leave the shaft all the way out and put the cap on. Then just spent ages bleeding them.
Got them to about 10% rebound which I think will be a nice feel. I swear my 009 alloy shocks weren't this hard. My photon is done in 30mins with 10%.
10-20-2010, 06:02 PM
#528
There's two things you can do with the standard shocks to get minimal rebound. The first is to push the shock shaft in before you screw the top cap on.
If there's still too much rebound you can bleed the shocks by unscrewing the bottom cap and then slowly push the shock shaft in again. This should get rid of a bit of excess oil.
Jonny
If there's still too much rebound you can bleed the shocks by unscrewing the bottom cap and then slowly push the shock shaft in again. This should get rid of a bit of excess oil.
Jonny
I recommend trying to get your hands on some of the new shallow bladders that have just been released with the t3'11 and give those a shot
10-20-2010, 08:04 PM
#529
2011
Anybody get their kits today ?Billy at speedworld posted he got his today and sold out.I cant wait to get mine Even going to go with a new paint scheme for this one.
10-21-2010, 01:38 AM
#530
Upper bulkhead arrive again !
10-21-2010, 03:04 PM
#531
Tech Regular
Just the shocks and transponder to fit and its done.
10-21-2010, 03:25 PM
#533
This is generally the method that I use, but another thing making it difficult to get less rebound is the fact that the piston/shaft can hit the standard "deep" bladder when fully compressed.
I recommend trying to get your hands on some of the new shallow bladders that have just been released with the t3'11 and give those a shot
I recommend trying to get your hands on some of the new shallow bladders that have just been released with the t3'11 and give those a shot
10-21-2010, 04:03 PM
#534
I just got mine this afternoon, going to be busy building it tonight 
10-21-2010, 06:10 PM
#535
10-21-2010, 09:52 PM
#538
10-21-2010, 11:39 PM
#539
Tech Initiate
50% FINISHED~
10-22-2010, 01:09 PM
#540
Xray T3'11 kits are here
Hi Guys,
The Xray T3'11 kits have arrived at Speedtech RC. We have very limited quantities. Get'em while they last.
Have a good weekend,
Jeff
The Xray T3'11 kits have arrived at Speedtech RC. We have very limited quantities. Get'em while they last.
Have a good weekend,
Jeff
