Turbo 35 GFX Problem
Hi,
I had an problem with my charger ( CE GFX ) . My problem is when i am in the charge mode, disharge mode cycle and motor. The second line of the screen is illegilbe. It's not letters or numbers, it's symbol. And on the last mode ( save load etc ) i'm block in, the rotary dial not answer and i do switch off my power supply for restart in the first menu. And when i switch off the power, i had not the last sentece ( bad power...... ) It's very strange and i am very :cry: . What do you think of this? Thanks for your answer. Yann. |
sounds like the obvious answer, but give CE a call. i've dealt with them in the past and had great customer service (courteous, fast turnaround, fair prices).
|
Yes, CE has great customer service.
Call CE, they may be able to walk you through a "FACTORY" reset. I don't rmember how to do that on the GFX, but generaly, you hold a button while powering on. |
Hi yann,
Problems occurs after Sunday at Emerainville ?? Not a fuse problem ?? Stephane Magnier New Owner of a 415 !!! I'll need you for setup sheets ... |
Hi, ok thanks a lot for your answers.
I go contact CE for more info. But i prefer send a mail. Because i don't speak very well :( Wiget, yeap it's right. Not a fuse a problem i had change all. And same result. One fuse it's for power supply and two for batteries. Thank Yann. |
|
Ok Tres, Thanks a lot.
Yann. |
:D Hi, it's ok now,
i had receive an mail from Jim Bailey. You can reset the memory by holding down the PAGE button during power up until you see the message: SYSTEM INIT. And it's ok now, i'm so happy. Thanks all. Yann |
cool, glad it's fixed....
|
All times are GMT -7. It is currently 03:51 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.