RedBullFiXX

iTrader: (34)

R12W is wide vers of R12
R12C is wide with crank steering
http://www.rc-race-and-drift-japan.c...oducts_id=4203

CFR

Do Futaba do a suitable sized servo for the R12c?

I know there's the Sanwa SRG-HR & Spektrum A5040

This chassis with centre point steering
http://www.teamyokomo.eu/yokomo-euro...49-Yokomo-R12C

CFR

some news on facebook saying Mobgums will have rims & foams to suit car September this year.

CFR

Who sells them?

Zooberg

What is the track Wide in rear with Jaco and other tire?


Any one have R12C car for sale?

Options and spear parts?

sdunnmcp

These wheels have the center offset similar to the Yokomo wheels and are available here in the USA.
https://www.facebook.com/ProOneRc

You would still need to run the Pro One hubs but they are inexpensive, $15 pair.

CFR

Were these parts just used to adjust the front springs on PRE R12C cars?

Mr. Blonde

He guys!
Yes, its true, MobGums will have a Yokomo offset 1/12 rear tyre from september on.
They will be the same than our current rear wheel as far as the design is concerned, just with the Yok offset.

You can check the news from time to time on www.speedtechrc.de

Later!
Markus Mobers-Speedtech RC Germany

CFR

2013 New Model R12??

Damper tube front end rather than cross damper?

AdrianM

iTrader: (4)

Probably Matsukura's new ride for the 2014 Worlds on asphalt.

Tiburon

iTrader: (7)

Hi, just built the car, does anyone how much I have to shim to use a Asso 12r5.1 axle? I have yokomo pre-mounts on their way, but I don't think they are going to me here on time for the next race.
Thanks.

ongbenghui

iTrader: (5)

If yours is R12C, I don't think AE axle will work. The offset is too much.
If yours is an old R12, then AE axle will fit nicely. I have tried it and I didn't use any shim.

CFR

AE axle or similar fits the R12C. Just needs shimming correctly.

Spacers are made from inner bearing race until I find some alloy spacers

1. R5 axle with 1 shim on diff end and two bearing inner races. Spacer was from BMI car.
2. R12C axle with shims either end
3. R12C with spacers and less shims

Tiburon

iTrader: (7)

cool, I actually found some aluminum stock that will slip over the axle as a shim, I can cut it at any length. you guy's wouldn't happen to know how much each side has to be spaced in mm would you? hopefully those tires show up tomorrow so I don't have to do this.

Thanks in advance.

Tiburon

iTrader: (7)

is there anyone here with mounted/unmounted yokomo tires? I hate ordering overseas, my tires are stuck in customs.

by the way, in regards to the earlier posts, this is the R12W chassis not the new C-chassis.