R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Electric On-Road (https://www.rctech.net/forum/electric-road-2/)
-   -   belts: cutting every OTHER tooth??? (https://www.rctech.net/forum/electric-road/39474-belts-cutting-every-other-tooth.html)

xray racer 05-05-2004 12:59 AM

hey, okay i gather so far that cutting every second tooth off the front diff pulley will give the most benefit right???

so now then... how do i do it? dremel every second tooth flat?

FlyinGT 05-05-2004 01:56 AM

yeah i've done it recently to the belts of my TA04 R

i did feel a difference ....... i could use my pinky on the hex hub an move the drivetrain .......... i couldn't b 4 !!
felt smoother when racing........ car would glide into corners.... rather than come to a quick stop n lose all my speed !!

team_tamiya 05-05-2004 03:09 AM

Yeah I have an R to, how far did you cut into each tooth. Have you done anything else to your drive train.

FlyinGT 05-05-2004 03:39 AM

Use A nail clipper .......!!
 
I used a nail clipper ....... to cut the belt .... i cut enough so that its flat an even
when u look at the belt side on ......... u cut it so it looks like the tooth was never there ........ exatly where it would start to rise up an ....like a hill then a flat ... then a hill ....... u should get my point(not very good at explaining things >>>!!:D :D

i've only done this so far ......... not touching the pulleys just yet .may b when i get some spare ones to play around with !!


All times are GMT -7. It is currently 09:45 PM.

Powered By: vBulletin v3.9.3.8
Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.