Attention: Jeff Cuffs
#1
Attention: Jeff Cuffs
Hi Jeff, I have a few questions for you. 1/12 scale 13.5 - need a Tekin speedo setup and rollout for a small 60x60 track. Can you post your Phi '09 setup from Snowbirds or your latest rubber setup for 13.5 and 17.5 as well as speedo settings?
Thanks,
Mark Frechette
Thanks,
Mark Frechette
#2
#4
Thanks Jeff, for the quick reply. I do have the new arms, what's the best working setup you run now.
Thanks again,
Mark Frechette
Thanks again,
Mark Frechette
#6
Hi Jeff
Can you give me the general setting for 4 cell batteries power with 17.5.RS Pro
I beleive the track is 60X80...Thanks
Can you give me the general setting for 4 cell batteries power with 17.5.RS Pro
I beleive the track is 60X80...Thanks
#7
Tech Master
iTrader: (2)
HMMM i havent run 4 cell in a 12th scale with brushless with the new software. This is just a starting point i would start at but remember the key is keeping an eye on temp so u dont cook a motor in practice. Throttle profile 5 neutral width 10, boost 40 turbo 10 .2 delay 2400 to 10000 rpm range. 2.0 ramp rate. start with a 76spur and a 44 pinion. Let me know how you make out
#8
HMMM i havent run 4 cell in a 12th scale with brushless with the new software. This is just a starting point i would start at but remember the key is keeping an eye on temp so u dont cook a motor in practice. Throttle profile 5 neutral width 10, boost 40 turbo 10 .2 delay 2400 to 10000 rpm range. 2.0 ramp rate. start with a 76spur and a 44 pinion. Let me know how you make out
#9
Jeff,
Arms - front and rear, are they spaced forward, middle, or back? Are you running the double lower shock tower in the rear and do you run a solid axle or one-way. Could you also give me a speedo setup for 13.5/17.5 rubber.
Thanks again,
Mark Frechette
Arms - front and rear, are they spaced forward, middle, or back? Are you running the double lower shock tower in the rear and do you run a solid axle or one-way. Could you also give me a speedo setup for 13.5/17.5 rubber.
Thanks again,
Mark Frechette