BMI Racing "Copperhead 12" discussion and support
#511
Hey Jason just wondering if the ch12 will be coming with the spring,shock oil and damper tube oil that you think will be used with med to high bite carpet, if not could you post what you think we should have ready for the build so we are as close to the right setup, and you mentioned you use thin servo tape under your lipo pack along with tape and just leave the batt in. would the parma servo tape be thin enough for this. thanks
mike
mike
#515
Okay, that is nice to know then... Jason, did I get it right? Does the new front end also have a damper tube supplied?
It's getting closer and closer now... Yummieeeeeee
It's getting closer and closer now... Yummieeeeeee
#517
Haha... And still I understood what you were saying
Very nice... I will look around here for some of these lubes then. I don't have them in my pitbox. Is that ShurLube the lube I should get or will any tube lube do the job?
Very nice... I will look around here for some of these lubes then. I don't have them in my pitbox. Is that ShurLube the lube I should get or will any tube lube do the job?
#519
thank you very much jason need to order this stuff asap
#520
Tech Champion
Perhaps you can use your influence to get them to change the bottles they use They keep leaking on me
#521
Tech Elite
iTrader: (51)
Join Date: Feb 2002
Location: Comin at ya from a distant galaxy
Posts: 2,926
Trader Rating: 51 (100%+)
#522
Tech Champion
Yeah I did only use a small hole in the tip. But with travel the bottle are often laying on their side instead of up and down...combine that with the Hawaii heat in the back of my car and yeah...they still leaked. Right now I'm debating if it is going to be worth the time to try and clean them up or just buy a new set.
#524
Sounds like music to my ears Jason... Almost there buddy! This will be a big day in RC racing when its done...