BMI Racing "Copperhead 12" discussion and support
#2597
Jason, you planning on being able to supply parts for the older chassis ? Only ask because I'd like to pick up a 12RR and a CH (if I can find them) for my collection. And btw....WHEN WILL WE HAVE A NEW BMI CAR ??
Sorry Man...had to do it.
Sorry Man...had to do it.
#2598
Jason do you have any 1.8mm flexplates for the wishbone front end? I need to buy a few sets. Also need a couple of sets of rear flex plates for the rear for tuning.
#2599
I only have 1.5mm front flex plates in stock. I have thin and thick rear flex plates in stock. Shoot me an email at [email protected] and I will get you taken care of.
#2601
Been quiet here, any news on the new car?
#2602
Any word on a new BMI car?
#2603
the last time I went to the website it was still up but the on-line store portion did not work, so I'm guessing that BMI is dead.
#2604
Not dead buddy, just really busy. I will be back. I have alot of big contract work that is very demanding. It is hard to get the time these days to release the new car. And the frustrations of watching the latest innovations i worked a long time on get snagged really sucked. I knew i shouldnt have shown anything at Snowbirds 2 years ago.lol Word moves fast at big races and apparently, a few things must have grabbed some attention. I just wish I could have released it as scheduled. Oh well. Family comes first and my little guy needed me.
Anyway, BMI is not a fly by night small company. We have been around for 35 years and growing at a rapid pace. Im not going anywhere. I just had to put the RC stuff on hold for a bit.
Anyway, BMI is not a fly by night small company. We have been around for 35 years and growing at a rapid pace. Im not going anywhere. I just had to put the RC stuff on hold for a bit.
#2606
Thats good to hear Jason.
#2607
Tech Apprentice
I need a few parts
Jason when you get time. I need a few parts (pivot ball) for my copperhead 12 scale front end.
Thanks,
Joe
Thanks,
Joe
#2608
If anyone that ran the copperhead has any parts left over shoot me a pm, in need of a few things.
#2609
Tech Addict
iTrader: (3)
What all do you need?
#2610
I will happily sell my car (it has the new front end) and all the parts I have, many of which are NIP. I'm not sure how much to charge, and I'm at work so I can't get you the details of what I have until later. If you want I can also check with my LHS as they carried parts just for me and I they have some left.
What all do you need?
What all do you need?
PM sent