Brushless HELP
#1
Tech Apprentice
Thread Starter
Brushless HELP
I have just installed a brushless system and it will not run.
Specs: LRP speedo and Trinity Pulse 17.5 motor
The motor is making a humming squeling noise when throttle is pulled. The motor end bell gets warm near the wire connections. The motor will not rotate when throttle is applied.
I have double checked the wiring, preformed the setup for the speedo.
The motor spins freely when no power is applied.
The steering servo functions ok.
Open for suggestions??
Thanks,
M2Racing
Specs: LRP speedo and Trinity Pulse 17.5 motor
The motor is making a humming squeling noise when throttle is pulled. The motor end bell gets warm near the wire connections. The motor will not rotate when throttle is applied.
I have double checked the wiring, preformed the setup for the speedo.
The motor spins freely when no power is applied.
The steering servo functions ok.
Open for suggestions??
Thanks,
M2Racing
#2
Tech Champion
Sounds like you have the power wires in the wrong order. The endbell getting warm would be a sign of that...or you might have a short somewhere. Make sure when you soldered the wires on the solder didn't bridge across the connections.
#4
Tech Apprentice
Thread Starter
I don't have a Hall sensor wire.
Could that be it?
Is that required on this motor?
M2Racing
Could that be it?
Is that required on this motor?
M2Racing
#5
#6
Tech Apprentice
Thread Starter
It was indeed the missing sensor wire.
After I installed it motor runs fine!
Yeah!
Thanks,
M2Racing
After I installed it motor runs fine!
Yeah!
Thanks,
M2Racing