Carbide Cutter for AC Cobra tire Lathe
#1
Tech Initiate
Thread Starter
Carbide Cutter for AC Cobra tire Lathe
Where can I find a Carbide cutter for an AC Cobra tire lathe?
#2
#3
Tech Initiate
Thread Starter
Carbide Cutter
I called Debbie's World and they are out of them at $34.95 each. I emialed Speed tech and haven't got an answer yet. Do you remember the brand name of the cutter?
#4
#5
Tech Initiate
Thread Starter
Micro Carbid Cutter
I purchased the fine micro carbide cutter from Rob Murdock. $25 plus shipping priority mail. Rob sold me on the fine cutter versus the course cutter, based on the fact that I run 1/10 Touring car and 1/12 scale only.
Thanx, to all that have tried to help me!
Brant
Thanx, to all that have tried to help me!
Brant
#6
#7
Do these bits work with something like the Trackside truer? I'd love to get rid of that sanding drum....
#8
Tech Adept
Hudy has them since their lathe uses them but you may need to make an adpater.
#10
Tech Adept
Originally posted by BIGDON18
can somebody post a pic of one of these cutters ,, iam currently using a snake skin cutter.
BIGDN
can somebody post a pic of one of these cutters ,, iam currently using a snake skin cutter.
BIGDN
#11
Tech Initiate
Thread Starter
Carbide cutter for AC Cobra tire lathe
BigDon18,
The Hudy cutter does not look like it will fit in the AC or trackside truer.
I believe the AC Cobra cutter has to have a 1/4 in round shank. I should have my cutter in a few days. If I can get it to work, I could take a digital picture and post it for you.
I ordered the cutter from
http://members.willinet.net/bmurdock...Hobby_Shop.htm
There is no picture on the website.
The Hudy cutter does not look like it will fit in the AC or trackside truer.
I believe the AC Cobra cutter has to have a 1/4 in round shank. I should have my cutter in a few days. If I can get it to work, I could take a digital picture and post it for you.
I ordered the cutter from
http://members.willinet.net/bmurdock...Hobby_Shop.htm
There is no picture on the website.
#13
Go to www.micromark.com. Part # 81961 is the one I am using. It's a coarse one. They have a fine one too. 15.95 a piece.
Last edited by akrcracer; 01-22-2004 at 08:01 AM.
#14
Tech Initiate
Thread Starter
Carbide Cutter from MicroMark
AKRCRACER,
Does the cutter you bought from micro mark have a 1/4 inch shank that fits directly into the AC Cobra tool holder?
Does the cutter you bought from micro mark have a 1/4 inch shank that fits directly into the AC Cobra tool holder?
#15
Yes it does.. You can buy either a corase or fine with a 1/4 shank.. Part # for fine is 81962. Go to site and punch in part # You will find both.
Last edited by akrcracer; 01-22-2004 at 09:33 AM.