Ofna JL-10 E
#406
Tech Rookie
#407
I don't have an ESC with dynamic timing (yet!), but I've been running 4.93 FDR. Track is a smaller carpet, fast.
Running 69/35 for gears.
Running 69/35 for gears.
#408
now...
Last edited by 1555Racing; 04-05-2010 at 06:16 AM. Reason: more photos
#409
Nice, is that a HPI 200mm body?
#410
#411
oh nice do i see candy blue on the bottom of the skirt? my toyota soarer is the same except its clear all over because i accidentally forgot to back it.
#412
Translucent Blue Tamiya...
I did not back it intentionally, I dig the results, thank you.
#414
I don't know about the aerodynamics.....
However, if curb appeal where part of the equation, you'd be a stunna'..
when and where?
when and where?
#416
Tech Master
iTrader: (5)
Sorry your question wasn't answered earlier, I would suggest something around a 4.2-4.5 if your carpet track is decently small. I ran a 3.9 at a carpet track that was maybe 75x45 with a regular Novak 17.5/GTB and it wasn't too hot but got the right amount of punch in the infield. Just keep an eye on temps and stay smooth/progressive with the throttle. Any ideas on the dimensions of your track? Good luck and have fun!
#417
The guys with non-boost ESCs were 4.6ish.
#418
im a Nissan guy and yet i run toyota bodies, haha especially the soarer at the carpet tracks with the setup i got it runs pretty dang good. Joe your my next target in RCGT. My Ofna JL10 IS going to do good.
#419
Tech Master
iTrader: (32)
hey everyone, just thought id see if there was any interest in hinge pin holders that would pull the arms in 2.5mm each side to bring the car to a legal width for roar or other bigger races that tech car width. i should have the plastic prototypes done this weekend and if they work well will send them off to my machinist to have them cut out of aluminum. have no clue what the price will be but im sure it would be along the lines of most aluminum option parts.
just thought id ask.
just thought id ask.