dots/flappers for clik-trak
Until CRC releases their clik-dots and clik-flappers, I'm looking for some creative dot/flapper ideas that can be easily velcroed to the carpet (for dots) and attached to the exposed ends of the clik-trak. I've looked at a couple of different cones/domes used for sports agility training, but don't have any ideas for securing them so they won't be knocked loose or raise up on impact and allow a car to get stuck under them. What do you other rug rats do to cover those exposed track ends?
-rocky b |
For flappers, at the Carpet Nats this year, we used 1/2 in thick vinyl moldings from Home Depot. They were about 8 inches wide, so we ripped them lengthwise in half (producing two 4 inch wide, 1/2 inch thick pieces). We then doubled them up to make a 1 inch thick piece. A single piece had too much give when used as a flapper. A few 1 1/4 inch deck screws screwed in from the face of the flapper (through both pieces) worked great to hold the pieces together.
|
Integy Corner Markers:
http://www.integy.com/cgi-bin/webc.c...146&p_catid=16 We duct tape them down. |
Originally Posted by CarbonJoe
(Post 5913495)
For flappers, at the Carpet Nats this year, we used 1/2 in thick vinyl moldings from Home Depot. They were about 8 inches wide, so we ripped them lengthwise in half (producing two 4 inch wide, 1/2 inch thick pieces). We then doubled them up to make a 1 inch thick piece. A single piece had too much give when used as a flapper. A few 1 1/4 inch deck screws screwed in from the face of the flapper (through both pieces) worked great to hold the pieces together.
|
Originally Posted by HB Moose
(Post 5917599)
I like the sound of it but I don't know exactly what type of molding you are talking about. What is it's "normal" usage so I know where to look in Home Depot.
|
I like the flapper idea, but how did you attach it to the track ends?
-rocky b |
Originally Posted by flatspunout
(Post 5917786)
I like the flapper idea, but how did you attach it to the track ends?
-rocky b |
All times are GMT -7. It is currently 11:57 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.