Tamiya F104 Pro!
#542
which is the weight of 104 ready to race?
#545
#546
Tech Elite
iTrader: (67)
#549
Tech Master
iTrader: (26)
Fitting Larger Lipos
I have been working on fitting IP 5000 lipos in the car. The problem I am having is with the ECS & RX trays. The parts that protrude at the top and bottom on the post on the inside are getting in the way. I have filed them down at an angle and have not left much and I am still needing about 2mm to make a good fit. I am thinking if I cut away the inside portion of the circular portion that goes on the post and then find some flat washers with the inside diameter to fit over the posts and glue them at the top and bottom of the tray, this would eliminate any obstruction on the inside of the battery compartment. I would think that CA should work to attach them together. Any thoughts or input on this idea?
#550
#551
"mid-august"
and with the $30 off it's $229
a little higher than I've seen locally
#552
Tech Initiate
iTrader: (3)
http://www.vellrip.com/store/product_details.asp?p=1920
hope this helps someone out.
#553
anybody try to fit in protoform Mulsanne LMP Body on f104 pro? will it fit on f104 pro?
#554
wondering if a smc-based lipo or even a reedy 5000 (w/wiring out side) will fit in the car?
R
R
#555
Here is my F104 as it is so far, I'm planning on using the Orion 2400 and 3200, as well as the Reedy 3400. All these batteries fit really well without any major modification, just a slight trimming down of the battery holder.
Some aero tweaks
Some aero tweaks
Last edited by gtypecanare; 08-02-2009 at 09:56 PM.