The Speed Passion Thread
#152
thanks for the info marcos. thats a great help for me.
#153
can you plug the GT2 Pro carbon edition into a computer if so where can i buy the plug.
#155
What does the LCD Programming box do for me. Does it let me make finer adjustment then the hand held it came with. Are there any update I can get for it off the web.
#159
Can anyone give me some suggestions. Thx
I just installed new ESC (SP GT2 Pro carbon edition) on T2009 xray. I intended to use LRP brushless motor (3.5 turn with 13mm sintered). and running Lipo 7.4v 5000nimh 30c.
My questions.
1. what is the best FDR (ratio) should I run?
2. What is the max temp of my motor and esc should I run for safety?
3. Can i measure torque using SP brushless analysis tool
I just installed new ESC (SP GT2 Pro carbon edition) on T2009 xray. I intended to use LRP brushless motor (3.5 turn with 13mm sintered). and running Lipo 7.4v 5000nimh 30c.
My questions.
1. what is the best FDR (ratio) should I run?
2. What is the max temp of my motor and esc should I run for safety?
3. Can i measure torque using SP brushless analysis tool
10.50 FDR is already safe range.
Max temp for Motor is 80C ( after 5 min run )
Max temp for ESC is 80C ( after 5 min run )
Max means max, don't cross over it.
#163
Tech Master
iTrader: (23)
I just picked up a LPF 2.0 carbon edition, and have one question. In the set up instructions it shows a LED that is somewhere on the solder posts side that you can look at while programming your radio set-up. For the life of me I dont see the LED, even a place for it. I even pealed the "A,B,C" decal back a little to see if it was covered up. However I do hear the set-up tones and got it done. Just wonder what I'm missing, or not seeing.
#164
R/C Tech Elite Member
iTrader: (37)
Just use the tones, the led's are burried lol
It was a small design flaw, they're in there but you can see them
It was a small design flaw, they're in there but you can see them
I just picked up a LPF 2.0 carbon edition, and have one question. In the set up instructions it shows a LED that is somewhere on the solder posts side that you can look at while programming your radio set-up. For the life of me I dont see the LED, even a place for it. I even pealed the "A,B,C" decal back a little to see if it was covered up. However I do hear the set-up tones and got it done. Just wonder what I'm missing, or not seeing.