The Speed Passion Thread
Tech Initiate
Hi i have a problem with my rev pro 1.1, it jerk when i throttle..it happen at low and high rpm..the red led will blink once (not continuous)when the jerk happen.
is the sensor wire plugged it and did you try a new sensor wire, is it wired correctly? a to a b to b and c to c is the receiver slot good and is the cable ok that goes to the receiver
For 17.5 Blinky sedan, what combo of can, rotor and sensor (max timing setting) would you recommend?
Orca 17.5 with the stock rotor a ht rotor I run the revention Speedo its a bullet I heard a few motors are good as well such as the reedy mach 2 and the thunder power z3r as for he rotor and can timing its really a matter of track size and traction I believe
Tech Initiate
Tech Initiate
Don't mind with the screeching sound, the wheels are hitting my box underneath...and this rev 1.1 is brand new out from the box..what baffle me is that there is a surge of volt that trigger that jerk or cog..if you saw that video you will notice the red led blink when it reach its point
Don't mind with the screeching sound, the wheels are hitting my box underneath...and this rev 1.1 is brand new out from the box..what baffle me is that there is a surge of volt that trigger that jerk or cog..if you saw that video you will notice the red led blink when it reach its point
Repost
Last edited by chad_h; 02-12-2014 at 03:36 PM. Reason: repost
Why does my led program box have an unidentified setting? After #6 drag brake with 9 values, #7 is neutral range according to the manual. However It has 9 values also and it's only supposed to have 6. #8 has 6 for the neutral range
I need to update it but can't because no wifi or laptop. I really think this should work out of the box without update.
I'm referring to page 13 in reventon R manual for info.
Esc is SP REVENTON R
Update: the manual has 2 different list of values. I found the correct one on on page 3 or 4 instead of page 13.
I need to update it but can't because no wifi or laptop. I really think this should work out of the box without update.
I'm referring to page 13 in reventon R manual for info.
Esc is SP REVENTON R
Update: the manual has 2 different list of values. I found the correct one on on page 3 or 4 instead of page 13.
Last edited by chad_h; 02-13-2014 at 08:57 AM. Reason: update: fixed
As this is a SpeedPassion thread, my question was SP specific.
Any SP representative attending the upcoming TITC event?
Tech Adept
Anybody with Trackstar 5.5T with Reventon PRO1.1
Need to change mechanical timing to work better with this ESC (How much)?
regards
Need to change mechanical timing to work better with this ESC (How much)?
regards
Good call! I'll be there with a brand new Reventon Pro 1.1 running in open brushless and so keen to know if there will be any factory support there!
Anyone got a good 13.5t open esc setup that'll be a good starter for ten for a TC?
Anyone got a good 13.5t open esc setup that'll be a good starter for ten for a TC?
Tech Rookie