T.O.P. Racing "Photon" 1/10 EP Touring Car
#3827
All kits purchased in hobby shops after Feb 1 2010 that are not USA SPEC we will honor and give a free suspension set. Obviously you have to provide proof of purchase from the USA.
#3828
#3830
#3833
Tech Adept
iTrader: (5)
Hi Jose, I believe the kits at Norcal don't have the extra suspension set in them. But once you purchase it just email us and we'll get you a set.
All kits purchased in hobby shops after Feb 1 2010 that are not USA SPEC we will honor and give a free suspension set. Obviously you have to provide proof of purchase from the USA.
All kits purchased in hobby shops after Feb 1 2010 that are not USA SPEC we will honor and give a free suspension set. Obviously you have to provide proof of purchase from the USA.
#3834
#3835
#3836
Regional Moderator
iTrader: (25)
#3837
Tech Elite
iTrader: (24)
Heres the setup I ran this weekend.
*Ran the 3 Hole 1.2mm pistons front and rear. Use the Dark bluish green 40 degree o rings in the shocks
Make sure your shocks are smooth, check the plastic part in the bottom and the o ring. When assembled with no oil the shaft move very freely.
*Ran the 3 Hole 1.2mm pistons front and rear. Use the Dark bluish green 40 degree o rings in the shocks
Make sure your shocks are smooth, check the plastic part in the bottom and the o ring. When assembled with no oil the shaft move very freely.
#3839
Tech Champion
iTrader: (3)
Join Date: Mar 2003
Location: Peoples Republic of Northern Virginia
Posts: 5,682
Trader Rating: 3 (100%+)
I personally have not ran RCGT with it, but I believe EJ has. Also check www.tchub.info
#3840
Heres the setup I ran this weekend.
*Ran the 3 Hole 1.2mm pistons front and rear. Use the Dark bluish green 40 degree o rings in the shocks
Make sure your shocks are smooth, check the plastic part in the bottom and the o ring. When assembled with no oil the shaft move very freely.
*Ran the 3 Hole 1.2mm pistons front and rear. Use the Dark bluish green 40 degree o rings in the shocks
Make sure your shocks are smooth, check the plastic part in the bottom and the o ring. When assembled with no oil the shaft move very freely.
roll center blocks?