R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Electric On-Road

Reply
 
Thread Tools Search this Thread
Old 06-01-2002, 09:51 AM   #196
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

I have a question on the Evo II....on right hand turns it is fine...on left hand turns the car over steers...both on power and off power...and ideas???

All shocks are the same length...car has been set on tweak station....
dtm is offline   Reply With Quote
Old 06-01-2002, 08:07 PM   #197
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Smile

how abt the setting on ur controller???...
not sure abt ur controller,but the ex1-mars has an option whereby the user can set too different setting turning left or turning rite...
ijnek is offline   Reply With Quote
Old 06-01-2002, 08:28 PM   #198
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

Quote:
Originally posted by ijnek
how abt the setting on ur controller???...
not sure abt ur controller,but the ex1-mars has an option whereby the user can set too different setting turning left or turning rite...
It can...but I would prefer to address any fundatmental car setup problems before going into the Tx to fiddle it!!
dtm is offline   Reply With Quote
Old 06-01-2002, 09:05 PM   #199
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Smile

well,...
not saying tat u should fiddle with the settings,but mayb check through the settings 2 check if there has been a mistake made...
it nvr hurts 2 check...
btw,wat controller r u using???...
if the problem still persists,mayb it's time for a re-build and still unable to re-solve the problem,mayb u could set the shocks on the affected side to a harder setting...
ijnek is offline   Reply With Quote
Old 06-01-2002, 09:21 PM   #200
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

Quote:
Originally posted by ijnek
well,...
not saying tat u should fiddle with the settings,but mayb check through the settings 2 check if there has been a mistake made...
it nvr hurts 2 check...
btw,wat controller r u using???...
if the problem still persists,mayb it's time for a re-build and still unable to re-solve the problem,mayb u could set the shocks on the affected side to a harder setting...
I'm using the 2000R. It was the first outing for the car so hopefully won't need a rebuild!

I just wanted to see if anyone else had this problem....because another friend with the Evo II had exactly the same handling characteristic as mine yesterday! Anyway, thks for the feedback.
dtm is offline   Reply With Quote
Old 06-01-2002, 09:25 PM   #201
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Smile

hmmm,...
could it b the placement of the equipment on board the car chassis???...the weight distribution with the batt on the chassis well???...

gd luck...
ijnek is offline   Reply With Quote
Old 06-01-2002, 10:49 PM   #202
Tech Adept
 
IceBerG71's Avatar
 
Join Date: Dec 2001
Location: Singapore RC racer
Posts: 159
Default

My TB01 also have a bit of this problem but is because 1 of my shock is leaking and also the TB01 actually is unbalance with the battery side being heavier...so i use my controller to offset the difference.....using ex1 to do it. i tot Evo2 is more balance. so actually Evo2 also face this problem. That means only belt car will be more balanced

IceBerG71 is offline   Reply With Quote
Old 06-01-2002, 10:56 PM   #203
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

Quote:
Originally posted by IceBerG71
My TB01 also have a bit of this problem but is because 1 of my shock is leaking and also the TB01 actually is unbalance with the battery side being heavier...so i use my controller to offset the difference.....using ex1 to do it. i tot Evo2 is more balance. so actually Evo2 also face this problem. That means only belt car will be more balanced

The EvoII is only more balanced if you use weights!!
dtm is offline   Reply With Quote
Old 06-01-2002, 11:04 PM   #204
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Smile

xtra weight on the car would seriously affected an electric car's performance,tat's y ppl playing electric car all try 2 make their car as light as possible...

iceberg71:
not exactly belt cars will be more balanced,it depends on how the batt and electronics are being placed thus afftecting the overall weight distribution.

in my opinion,the kyosho kx-1 would be 1 of the most balanced kit around wif it's batt along the centre line...
ijnek is offline   Reply With Quote
Old 06-01-2002, 11:13 PM   #205
Tech Master
 
Jack's Avatar
 
Join Date: Aug 2001
Location: sleepy town
Posts: 1,279
Default

Ice, a car having belt drive does not make it any more balance
it depend on your electronics placement and battery placement

DTM, could you descride your problem in more detail....
could you from drool setting
Jack is offline   Reply With Quote
Old 06-01-2002, 11:25 PM   #206
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

Quote:
Originally posted by Jack
Ice, a car having belt drive does not make it any more balance
it depend on your electronics placement and battery placement

DTM, could you descride your problem in more detail....
could you from drool setting
I tried several settings all with similar effects;

Started at;
Front
Camber 2 deg
Ride height 4mm
40wt oil
Yellow springs
Middle hole
No sway bars

Rear
Camber 1 deg
Ride height 5mm
50wt oil
Blue springs
Middle hole
No sway bars

By the end of the day ended up with;
Front
Camber 1 deg
Blue springs
hole furthest out

Rear
Camber 2 deg
Yellow springs
Hole furthest in

The car felt too stable except with quick movements of the steering (L/R)- then it was unstable!!

Off throttle going into left turn the car oversteered badly. Too much power in the middle of the turn and it oversteered again. You could drive it by applying light throttle to 'drift' around the corner.....Right hand turns no problems!!

I ended up with max 'down' rear downstops to try and 'plant' the rear- no good!

I was thinking of trying 30wt oil at the back with sway bar next week!!! That should steady the rear with quick steering changes but may not do much to the left turn bit!!!
dtm is offline   Reply With Quote
Old 06-02-2002, 12:26 AM   #207
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Default

i would figure out that it's most probably due to the uneven weight distribution due to the batt...

u in RC for racing or jus fun?...
it may sound stupid,but try putting some weight on the electronics side and see if it balances up...
ijnek is offline   Reply With Quote
Old 06-02-2002, 01:48 AM   #208
Tech Adept
 
IceBerG71's Avatar
 
Join Date: Dec 2001
Location: Singapore RC racer
Posts: 159
Default

Jack:

Battery placement is fixed for shaft driven car as it is on one side of the car. so the only option to play with is the elcectronic placements but i place my electronic like the normal usage way....

So what i can offset is only Tx settings. is that a good way???

Thanx for the advice
IceBerG71 is offline   Reply With Quote
Old 06-02-2002, 01:54 AM   #209
Tech Elite
 
ijnek's Avatar
 
Join Date: Apr 2002
Location: S'pore & M'sia, JB
Posts: 2,510
Send a message via ICQ to ijnek
Smile

use the Tx to offset,...hmmm,...
if u actually notice,the oversteer here might b referring to the moment when he is turning...
i believe with the ex1-mars,there is the option of setting different turning rate for right and left turns,so with tat,i believe u can actually offset the excessive turning...
but i dun think so all controllers have tat function,so a gd choice if u have the ex1-mars...
ijnek is offline   Reply With Quote
Old 06-02-2002, 06:34 AM   #210
dtm
Tech Champion
 
dtm's Avatar
 
Join Date: Aug 2001
Location: HKG
Posts: 7,551
Send a message via ICQ to dtm
Default

Quote:
Originally posted by ijnek
i would figure out that it's most probably due to the uneven weight distribution due to the batt...

u in RC for racing or jus fun?...
it may sound stupid,but try putting some weight on the electronics side and see if it balances up...
SERIOUS FUN!! However, the car must perform!! Otherwise I'm going back to my Xray!!
dtm is offline   Reply With Quote
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
Selling Schumacher Mi2, Tamiya M02, Tamiya TA04-S, Tamiya TB Evolution 3 Surikarn Ltd st_rob Australia For Sale/Trade 4 12-23-2008 07:37 PM
FS: Tamiya TB Evolution II (NEW) ivan3721 R/C Items: For Sale/Trade 1 05-18-2008 05:56 PM
FS: Tamiya TB Evolution 5 veecee Australia For Sale/Trade 3 07-20-2007 08:13 PM
tamiya tb evolution 5 b-man777 Electric On-Road 1 05-24-2006 11:38 AM
XXX-S GP VS Tamiya Evolution III capricess Electric On-Road 29 01-27-2003 08:49 AM



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



All times are GMT -7. It is currently 01:55 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net