reducing heat
I was wondering where would be the best spots for drilling a tc3 chasis for heat reduction
|
heat reduction of WHAT ? for the motor ? get a fan +heat sink. Don't weaken the zone where the motor sits.
For the speedo, its pointless drilling, except if it has an aluminium case. Then you can drill a few 10mm holes under it, and attach it with the least possible amount of thick double sided tape. Did it for my GM.:) Sorry for my english, and good luck. |
Get a TC4 chassis.
|
doesn't fit.:rolleyes:
|
All times are GMT -7. It is currently 09:14 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.