Go Back  R/C Tech Forums > General Forums > Electric On-Road
SMC 4000/25C/3.7V single cell Hardcase pack. >

SMC 4000/25C/3.7V single cell Hardcase pack.

SMC 4000/25C/3.7V single cell Hardcase pack.

Reply

Old 11-17-2008, 10:26 AM
  #1  
Company Representative
Thread Starter
iTrader: (2)
 
Danny/SMC's Avatar
 
Join Date: Oct 2001
Location: Elkton, VA
Posts: 3,097
Trader Rating: 2 (100%+)
Default SMC 4000/25C/3.7V single cell Hardcase pack.

Finally we just got in our new single cell Lipo with hardcase. We decided to go with 4000mAH as we feel this may help 12th scale mod to slowdown as the speeds are to fast at the moment and 4000 is plenty for the stock classes.

Part# 4025S 4000mAH 3.7 volt 25C

Retail: 75.00 Estimated Street Price: 55.00

Size: L93mm x W47mm x H20mm
Attached Thumbnails SMC 4000/25C/3.7V single cell Hardcase pack.-singlelipo1.jpg   SMC 4000/25C/3.7V single cell Hardcase pack.-singlelipo2.jpg  
Danny/SMC is offline  
Reply With Quote
Old 11-17-2008, 10:53 AM
  #2  
Tech Elite
 
Skiddins's Avatar
 
Join Date: Feb 2006
Location: Windsor, UK
Posts: 4,820
Default

What will the performance be like compared to a 4.8V 4cell pack?

I realise the car would require a receiver pack but will it be much slower than 4cell?

Thanks
Skiddins
Skiddins is offline  
Reply With Quote
Old 11-17-2008, 11:01 AM
  #3  
Tech Regular
iTrader: (17)
 
Triton3d's Avatar
 
Join Date: Oct 2008
Posts: 264
Trader Rating: 17 (100%+)
Default

Would it work on a Modified 1/12???
Triton3d is offline  
Reply With Quote
Old 11-17-2008, 11:07 AM
  #4  
Tech Fanatic
iTrader: (50)
 
buffalobill989's Avatar
 
Join Date: Aug 2004
Location: broken arrow, ok
Posts: 754
Trader Rating: 50 (100%+)
Default

dam 55 where can i get me one of them things
buffalobill989 is offline  
Reply With Quote
Old 11-17-2008, 11:09 AM
  #5  
Company Representative
Thread Starter
iTrader: (2)
 
Danny/SMC's Avatar
 
Join Date: Oct 2001
Location: Elkton, VA
Posts: 3,097
Trader Rating: 2 (100%+)
Default

At the moment a single cell Lipo pack will work but not for the entire 8 minutes as the current speed controls have a cutoff built in that cuts power to the motor to send to the receiver when it sees a certain voltage. Novak is working on a speed control that will not have this cutoff and I believe that the new KO speed control has a very low cutoff which means it should be fine.

Novak is doing a booster circuit that will allow the voltage of the pack to be bumped up so your reciever gets enough voltage.

So there needs to be a few things to be worked out as far as electronics go but once it's done the single cell Lipo pack will be great as it will allow you the benefits of Lipo in 12th scale.


As far as speeds go so far we have seen 13.5 single cell is the same speed as 4 cell 17.5 this means if you run on a very small track and 17.5 four cell is to fast then 17.5 single cell maybe the perfect speed.
Danny/SMC is offline  
Reply With Quote
Old 11-17-2008, 11:10 AM
  #6  
Tech Regular
iTrader: (2)
 
RC_Dan's Avatar
 
Join Date: Aug 2006
Location: Ft. Collins, CO
Posts: 478
Trader Rating: 2 (100%+)
Default

So rx pack required for sure with this? This could be a lot of fun with a 10.5 I think. Also, what is the weight compared to a 4 cell NiMh?
RC_Dan is offline  
Reply With Quote
Old 11-17-2008, 11:13 AM
  #7  
Tech Elite
iTrader: (24)
 
Carl Giordano's Avatar
 
Join Date: Nov 2004
Location: Upper Saddle River, NJ
Posts: 2,352
Trader Rating: 24 (100%+)
Default

Thank You...

Now if only the case was designed with channels to run motor wires under the pack it would be perfect...
Carl Giordano is offline  
Reply With Quote
Old 11-17-2008, 11:13 AM
  #8  
Ike
Tech Master
iTrader: (8)
 
Ike's Avatar
 
Join Date: Jan 2004
Location: Milwaukee, WI
Posts: 1,228
Trader Rating: 8 (100%+)
Default

Danny, I need a couple packs asap as I'm hoping this can be a launching point for getting 1/12th scale going again at Trackside. From whom will I be able to purchase and how soon?
Ike is offline  
Reply With Quote
Old 11-17-2008, 11:16 AM
  #9  
Company Representative
Thread Starter
iTrader: (2)
 
Danny/SMC's Avatar
 
Join Date: Oct 2001
Location: Elkton, VA
Posts: 3,097
Trader Rating: 2 (100%+)
Default

Originally Posted by RC_Dan View Post
So rx pack required for sure with this? This could be a lot of fun with a 10.5 I think. Also, what is the weight compared to a 4 cell NiMh?

The weight should be close to half of 4 cell 4600 pack. As far as reciever pack goes it's currently the only way to go but once Novak releases the booster circuit there will be no need for one.
Danny/SMC is offline  
Reply With Quote
Old 11-17-2008, 11:18 AM
  #10  
Company Representative
Thread Starter
iTrader: (2)
 
Danny/SMC's Avatar
 
Join Date: Oct 2001
Location: Elkton, VA
Posts: 3,097
Trader Rating: 2 (100%+)
Default

For those who want one now you can email me and we can sell you one as long as you can pay via Paypal.

[email protected]
Danny/SMC is offline  
Reply With Quote
Old 11-17-2008, 11:27 AM
  #11  
Tech Fanatic
iTrader: (50)
 
buffalobill989's Avatar
 
Join Date: Aug 2004
Location: broken arrow, ok
Posts: 754
Trader Rating: 50 (100%+)
Default

i will be ordering one as well and im sure once the other guys see it they will be on board to.....
buffalobill989 is offline  
Reply With Quote
Old 11-17-2008, 12:15 PM
  #12  
Ike
Tech Master
iTrader: (8)
 
Ike's Avatar
 
Join Date: Jan 2004
Location: Milwaukee, WI
Posts: 1,228
Trader Rating: 8 (100%+)
Default

You've got mail Danny!

What did you guys find best for rollout with a 13.5 in testing? This will be used at Trackside.
Ike is offline  
Reply With Quote
Old 11-17-2008, 12:24 PM
  #13  
Company Representative
Thread Starter
iTrader: (2)
 
Danny/SMC's Avatar
 
Join Date: Oct 2001
Location: Elkton, VA
Posts: 3,097
Trader Rating: 2 (100%+)
Default

I reccomend you get in touch with Donny Lia as he has tested allot with the single cell at his track. I think he may have posted info on the 5700 thread.
Danny/SMC is offline  
Reply With Quote
Old 11-17-2008, 12:42 PM
  #14  
Tech Elite
iTrader: (4)
 
KHoff7's Avatar
 
Join Date: Jan 2007
Posts: 3,166
Trader Rating: 4 (100%+)
Default

Email Sent
KHoff7 is offline  
Reply With Quote
Old 11-17-2008, 01:02 PM
  #15  
Tech Fanatic
 
losithrasher's Avatar
 
Join Date: Nov 2007
Posts: 791
Default

so will it make 8 mins with an rx pack?
losithrasher is offline  
Reply With Quote

Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Terms of Service