PPD TC setup plates. TC5, Mi3, Xray, Cyclone and ??
#152
Tech Master
iTrader: (18)
i used the plate on my 416...... just had to dremel two spots. better than waiting for a custom one. dremel where the motor mount brace is..and where the servo holder is. takes about 3 mins to do. now i have a plate on my car and im happy.
let me know if you guys need pix.
let me know if you guys need pix.
#153
i used the plate on my 416...... just had to dremel two spots. better than waiting for a custom one. dremel where the motor mount brace is..and where the servo holder is. takes about 3 mins to do. now i have a plate on my car and im happy.
let me know if you guys need pix.
let me know if you guys need pix.
I am curious, what plate did you adapt to a 416? I haven't layed out that chassis yet, but I'm sure 1 of the previous 3 should be not too far off.
Pic would be cool.
#156
Tech Champion
iTrader: (34)
I did plan to do a 416 plate, but need to wait until some of the Cyclone plates get sold to keep this program self supported.
I am curious, what plate did you adapt to a 416? I haven't layed out that chassis yet, but I'm sure 1 of the previous 3 should be not too far off.
Pic would be cool.
I am curious, what plate did you adapt to a 416? I haven't layed out that chassis yet, but I'm sure 1 of the previous 3 should be not too far off.
Pic would be cool.
Keep us up to date with what you're doing on the 416 ones, the Australian paso has fallen a heap since I bought my EZ lipo but that wont stop me getting one if you end up doing them
#160
Tech Elite
iTrader: (20)
Join Date: Sep 2001
Location: MEMBER OF THE "MWC" Mimi Wong Clan
Posts: 2,442
Trader Rating: 20 (100%+)
Anymore Cyclone plates available??? If so, gonna check funds!! Needing one of these units!!
#163
Brian,
I'm attempting to get a min of 5 backordered to run again. I'm at 3 now.
This way I can cover setup costs and dont have to sit on inventory
since they are costly to build.
I'll put your name on the list. It will prob. be min. 2-3 weeks.
Kevin Patterson
PPD