bgreenslade

I need some help figuring out my problem with my 1/12th scale.

The motor cuts in and out at 60% or more throttle and sometimes even sticks at full throttle.

I have change the receiver and tried 2 different speed controllers.

I'm using a Futaba 2.4 pm radio and receiver.
Tazer 12t ESC

If you can help please post

Thanks

Brad

boyntoncyclone

1st step, get all your wires up off the carbon fiber chassis, make sure your antenna has a clear route, not all jumbled up with the other wires. Also check to make sure all the shrink wrap on your batts are good, bare batteries touching carbon fiber chassis is bad. Try these two first and see if that clears it up.