Tamiya TB-03
#1456
@Callahan_88:
what width of rims do you use? they seem to be very large. with which body do you use these rims?
thanks
what width of rims do you use? they seem to be very large. with which body do you use these rims?
thanks
#1457
This one!
Itīs the new HPI LP32 and LP35 RAYS VOLKRACING RE30 wheels.
6mm offset in front and 9mm in the back.
The bodie is HPI Aero Supra.
http://www.hpiracing.com/products/en/3341/
#1458
that looks sick man!
that means that in the back you've got 35mm rims + 9mm offset?! Amazing body! Can you post a pic from the front, too?
thanks
that means that in the back you've got 35mm rims + 9mm offset?! Amazing body! Can you post a pic from the front, too?
thanks
#1459
#1461
I have to push the rear suspension arms as mutch forward as possible.
The front body post are allmost the same just a little bit more narrow on the TB-03.
The front body post are allmost the same just a little bit more narrow on the TB-03.
#1462
Tech Adept
Hi guys,
is it possible reduce the IDR from 2,438 to a lower ones i.e. 1,80 or something like that?
tnks
Max
is it possible reduce the IDR from 2,438 to a lower ones i.e. 1,80 or something like that?
tnks
Max
#1463
Tech Master
iTrader: (83)
Can anyone with a TB03 please tell me what 64p pinion and spur to use with an 8.5T LRP motor? I just need to know how many teeth on both, I can't figure out the whole FDR thing. I am a complete onroad newb and am ready to sell my brand new kit without even getting a motor in it.
#1465
Tech Elite
iTrader: (25)
Can anyone with a TB03 please tell me what 64p pinion and spur to use with an 8.5T LRP motor? I just need to know how many teeth on both, I can't figure out the whole FDR thing. I am a complete onroad newb and am ready to sell my brand new kit without even getting a motor in it.
#1467
Tech Adept
the problem is with the coupling between the dif and the propeller shaft pinion, if you have on it too much play you will destroy it with any kind of motor, when you are going to assemble it you must first assemble it as per instruction, then check the ammount of play, then if more then 0,20 / 0,25 mm you must add shims until reach the correct play.
Hoping to clear your doubt.
Max
#1468
Tech Elite
iTrader: (25)
The gears that are in the TB03 are the same as the EVO 5. So Mod motors are not problem as long as the gears are shimmed correctly.
#1470
Tech Master
iTrader: (83)
Will this pinion work with the stock 64T 06 module spur gear? Not sure if 0.6m is the same as 06 module.
http://www3.towerhobbies.com/cgi-bin...&I=LXUFK1&P=SM
http://www3.towerhobbies.com/cgi-bin...&I=LXUFK1&P=SM