TRF414M, 404x, 414, 414X
#2476
Tech Addict
Calvin,
I've been using the same outdrives for 6 months... Indeed under full throttle they tend to twist a little, but this gives the car some smoothness.
Try using the anti wear grease...
I've been using the same outdrives for 6 months... Indeed under full throttle they tend to twist a little, but this gives the car some smoothness.
Try using the anti wear grease...
#2477
on the end of the dog bone?
whats this anti-wear grease
whats this anti-wear grease
#2478
Tech Addict
I'll say on the endS of the dog bone. The anti wear grease is supposedly given with the TA04 / TRF 414M series. It's a light grey and sticky grease. Put it on each surface subject to wear in your dogbones. Of course, you'll need to clean them sometimes (mainly to add some new grease).
I know some people say never put grease in your dogbones, but this one just works (and ROCKS).
I know some people say never put grease in your dogbones, but this one just works (and ROCKS).
#2479
the thing i dont like about the derlin ones is there white. they look very dirty after a couple of races
#2480
Tech Addict
Indeed, but this is the color of the material, any black one is not delrin...
#2481
ok i'll give it a shot.....
but i dont have any spare derlin's one of them is ripped but not so bad...
my original spare one is also ripped up.....
but i dont have any spare derlin's one of them is ripped but not so bad...
my original spare one is also ripped up.....
#2482
Brushless 414MII
Hi,
Just curious to know if anyone out there is running a Novak Brushless Powered 414MII. I am curious to hear how it goes with the brushless and how tight is the fit. Any pics would be much appreciated...
steevo
Just curious to know if anyone out there is running a Novak Brushless Powered 414MII. I am curious to hear how it goes with the brushless and how tight is the fit. Any pics would be much appreciated...
steevo
#2484
kicks all of there butts
evo 3's
tc3's
sd's
all of them!!
evo 3's
tc3's
sd's
all of them!!
#2485
Tech Master
iTrader: (1)
Re: Brushless 414MII
Originally posted by Steevo
Hi,
Just curious to know if anyone out there is running a Novak Brushless Powered 414MII. I am curious to hear how it goes with the brushless and how tight is the fit. Any pics would be much appreciated...
steevo
Hi,
Just curious to know if anyone out there is running a Novak Brushless Powered 414MII. I am curious to hear how it goes with the brushless and how tight is the fit. Any pics would be much appreciated...
steevo
Nice to see your enjoying the 414. Paul Smith in Aust runs brushless on a 414 i think.
#2489
was it the ssg/light weight bulkheads etc etc square upgrades on the buy/sell forum?