Tekin RS ESC sensored
Tech Fanatic
iTrader: (18)
Tech Fanatic
iTrader: (18)
Any one have a 1/12th 13.5 1c blinky gearing with a 13.5 D3 motor on a 100'x45' carpet track what rotor would be good the 1c or the one that comes with it?
Tech Master
iTrader: (19)
I run the stock rotor in mine, I run an 86mm rollout and my temps have never gotten above 135. I run a 100 by 38 foot track so it should be close, you may be able to go up a tooth or two on your pinion though.
Tech Addict
iTrader: (24)
Tech Lord
iTrader: (103)
Tech Addict
iTrader: (24)
Is it ok to connect the cap with some wire?
I want it a little further away because it would be a cleaner install.
I want it a little further away because it would be a cleaner install.
Tech Lord
iTrader: (103)
Tech Lord
iTrader: (103)
Tech Fanatic
Tech Regular
iTrader: (9)
Hey i have the rs speed control and just bought the hotwire interface for it. I just have a quick question how do i put the speed control in blinky mode. Please help new to this stuff
you have to load 212 software in the speedo.
the computer will basicly tell you how.
then, it will be TP 1 for blinky in the speedo.
it's all on the Tekin site too.
the computer will basicly tell you how.
then, it will be TP 1 for blinky in the speedo.
it's all on the Tekin site too.
Tech Regular
iTrader: (9)
thanks i got it know so easy to follow off the website
Tech Master
iTrader: (7)
Could I push an RS to 6.5 with some boost?... if I add a fan to blow across the post?