Tekin RS ESC sensored
Tech Regular
iTrader: (7)
Anybody????
Randy,
Is it possible to install any type temp sensor so you can monitor motor temps in the data logger? None of my motors contain a temp sensor. I just purchased your new rsx and a data log for motor temps would be useful for mod sedan. Sorry it this topic has been covered.
Thanks
Is it possible to install any type temp sensor so you can monitor motor temps in the data logger? None of my motors contain a temp sensor. I just purchased your new rsx and a data log for motor temps would be useful for mod sedan. Sorry it this topic has been covered.
Thanks
That's fast lap so your gearing will likely be much different. Hara's 11.5 setup was on a huge outdoor track.
Tech Adept
all the setups i've seen vary so much,been new to tekin
i just wanted a safe starting point. carn't see anything for
10.5 touring car on that link.
thanks rick..
i just wanted a safe starting point. carn't see anything for
10.5 touring car on that link.
thanks rick..
Tech Regular
iTrader: (2)
Wondering about a 14 second lap times with that type power available. That must be a very large and/or very technical carpet track. We race on a 82' x 36' Ozite rug and fast lap times for 17.5 blinky is always sub 10 seconds on several different layouts.
how do I set reverse n tekin rs gen 2 ?
Tech Regular
iTrader: (2)
Tech Regular
iTrader: (2)
That's very easy with the Hotwire.
Or by onboard tuning here:
http://www.teamtekin.com/manuals/RSG2_Manual.pdf
Or by onboard tuning here:
http://www.teamtekin.com/manuals/RSG2_Manual.pdf
1s esc?
I have not heard about a 1s esc for a while, is there still going to be one built or did I miss something?
Tekin RS Gen 1
cuts out power when I case jumps, but a few seconds later, after rolling off the jump it comes back to life. Settings not being changed by wires making a button push.
Is this a common issue, or a bad cap, sensor board/wire, etc?
cuts out power when I case jumps, but a few seconds later, after rolling off the jump it comes back to life. Settings not being changed by wires making a button push.
Is this a common issue, or a bad cap, sensor board/wire, etc?
What radio system and servo?
Randy, it's a DX3R/Savox setup with a Novak cap plugged into the receiver.
Have two others with the same setup. Happens when I case a large double or triple. Any hard landing, where I bottom out.
Have two others with the same setup. Happens when I case a large double or triple. Any hard landing, where I bottom out.
Do me a favor and please on the bench car on wiggle the steering and watch the receiver led. Does it flicker at all? If so unplug the cap, retest. Worse or better?
Tech Elite
iTrader: (28)
Does depressing one or both of the buttons on top of the ESC cause the same symptoms?
If so, the internals of one or both of these switches may be actuating under the hard chassis slap. Use thicker servo tape (double up on what you normally use) to see if the issue goes away.