Tekin RS ESC sensored
Tech Elite
iTrader: (93)
Did you pay with paypal? If so ask for a refund and send it back to the seller. This isn't the thread to be complaining about a seller on RCtech though.
Tech Initiate
starting to get this car working good now, but the problems is now that after maybe 3-5min it will loose power. temps are good,esc have 4led, motor is about 50-60c, battery is cold. (outside temp is also low,10-15c) is it the battery that is the problem? ( 5000mah 40c) it has been used for some time...
motor timing 0
Fdr 8.3
start 14000
end 30000
boost 28
turbo 15
ramp 2
delay .2
Hi!
starting to get this car working good now, but the problems is now that after maybe 3-5min it will loose power. temps are good,esc have 4led, motor is about 50-60c, battery is cold. (outside temp is also low,10-15c) is it the battery that is the problem? ( 5000mah 40c) it has been used for some time...
motor timing 0
Fdr 8.3
start 14000
end 30000
boost 28
turbo 15
ramp 2
delay .2
starting to get this car working good now, but the problems is now that after maybe 3-5min it will loose power. temps are good,esc have 4led, motor is about 50-60c, battery is cold. (outside temp is also low,10-15c) is it the battery that is the problem? ( 5000mah 40c) it has been used for some time...
motor timing 0
Fdr 8.3
start 14000
end 30000
boost 28
turbo 15
ramp 2
delay .2
How many mah's are yo burning up in 5 minutes?
Funny clicking.
I'm just putting my sedan back together for winter. I took the RS pro and updated it to the latest firmware. I have a Ballistic 10.5 in the sedan.
There is a strange cyclic clicking that occurs sometimes at neutral. I'm guessing it's about 4-6 clicks in .1 seconds on a cycle of about .6 seconds. So the motor is making the clicking, I can see and feel the pinion move back and forth.
I can get the clicking to go away by touching the throttle or rolling the car a little bit.
Any ideas what that is? Everything works fine otherwise.
There is a strange cyclic clicking that occurs sometimes at neutral. I'm guessing it's about 4-6 clicks in .1 seconds on a cycle of about .6 seconds. So the motor is making the clicking, I can see and feel the pinion move back and forth.
I can get the clicking to go away by touching the throttle or rolling the car a little bit.
Any ideas what that is? Everything works fine otherwise.
Your NW is too low. Bump it by 5.
Tech Initiate
about 1900mah in 5 min tested today, but it get`s soft in under 3 min.... 7.7v after 5 min.
do you se anyting in the setup that can help this issue? or is it just a battery problem?
Tech Master
iTrader: (26)
Having an issue with my RS.
ESC drops power on the motor at random, down to about 50%. New sensor wire didn't fix it, nor did changing motors.
Is this a known issue? Is there a fix?
ESC drops power on the motor at random, down to about 50%. New sensor wire didn't fix it, nor did changing motors.
Is this a known issue? Is there a fix?
Tech Initiate
Tech Master
iTrader: (21)
Hey, I was just wondering if I could wrap some electrical tape or something around the solder posts of my rs esc so they don't short?
Hi.
Can the RS or RS Pro handle 1 cell lipo batteries in 1/12th scale applications without the use of receiver packs?
Thanks.
Can the RS or RS Pro handle 1 cell lipo batteries in 1/12th scale applications without the use of receiver packs?
Thanks.
R/C Tech Elite Member
iTrader: (28)
Tech Fanatic
iTrader: (37)
Tech Champion
iTrader: (34)
Cranked NW to 100, still does it. About 5 clicks on a .76 second cycle. Video for clarification:
I'll try a different motor too.
+ YouTube Video | |
I'll try a different motor too.
Last edited by JordanCatalano; 09-13-2012 at 10:26 PM.
Tech Elite
iTrader: (31)
We run boosted 17.5 TC onroad on a small-medium outdoor track (30m/100' straight). I currently have a Fantom Ion3 in the car and started with Hara's setup:
Boost: 50
Turbo: 14
Start: 5,400rpm
End: 20,000rpm
Delay: .14
Ramp: 2.0
I started with an FDR of around 6.2.
Overall, it feels like not enough bottom end, but seems to be accelerating hard still towards the end of the straight. Looks like a setup for a bigger track. Temps after 5mins are in the 60degC range.
I'm hoping someone has some suggestions for boosting the bottom end. I don't really think I want to gear much shorter than that, so thinking of lowering the rpm range (start & end) but dropping the boost a little to keep temps in check. Has anyone found a good combination for this?
Boost: 50
Turbo: 14
Start: 5,400rpm
End: 20,000rpm
Delay: .14
Ramp: 2.0
I started with an FDR of around 6.2.
Overall, it feels like not enough bottom end, but seems to be accelerating hard still towards the end of the straight. Looks like a setup for a bigger track. Temps after 5mins are in the 60degC range.
I'm hoping someone has some suggestions for boosting the bottom end. I don't really think I want to gear much shorter than that, so thinking of lowering the rpm range (start & end) but dropping the boost a little to keep temps in check. Has anyone found a good combination for this?