Tekin RS ESC sensored

You're on Page 1023 of 1558
Go to
  • Quote: I'm new to this ESC....can someone explain a little more in depth about this trick. Is it legit and should I be running it? Thanks in advance.
    Yes it is legit. What it is on radios the end point will wander a little and teh esc will not see full speed. What you are doing is setting the end point on the radio down and calibrating the esc and then turning the end point past were it was calibrated so it will for sure see full throttle. If you have a problem with turbo working then not working, this is almost always the solution.
  • Quote: Just out of curiosity sake, did he check his batteries? I was out their at that race saturday and it was hot. One of the cells in the battieries could of gone flat as well.
    I changed the battery twice and put a new sensor wire on. I also recalabated the radio.

    The car runs perfect just no turbo or boost but when I hook it up to my laptop it shows turbo and boost. He said he did get in a bad wreck and after that it was flat on power. I will try the cap and if it doesn't help I will send it in for a check up.

    Thanks guys.
  • Quote: I changed the battery twice and put a new sensor wire on. I also recalabated the radio.

    The car runs perfect just no turbo or boost but when I hook it up to my laptop it shows turbo and boost. He said he did get in a bad wreck and after that it was flat on power. I will try the cap and if it doesn't help I will send it in for a check up.

    Thanks guys.
    2 more things you can try:

    1. Double check you are using 'sensored mode'.

    2. Load a previous (v200) firmware and see if turbo/boost is working. Then reload v203 and see if that works.

    Good luck.
  • Quote: HI MJC,

    Did you manage to solve the Team power on Tekin ESC problem? I've the same problem with yours. My Team Power motor working well on my Sphere TC but having some kind of sensor problem on my Tekin.
    Using Team Powers 11.5 with RsPro... no problem at all.
  • Quote: just wonder why it cannot match with this brand... any body from this thread having the same problem with this motor brand and know the solution?
    Yazid,

    Just sent you a PM.
  • Quote: 2 more things you can try:

    1. Double check you are using 'sensored mode'.

    2. Load a previous (v200) firmware and see if turbo/boost is working. Then reload v203 and see if that works.

    Good luck.
    I did in stall v200 and it did not have turbo. I then reinstall v203 set all the settings back to my race set up and still the same problem.

    Thanks for all the help guys but I can't come up with anything else so I will send it off tomorrow for a check up.
  • Just had great customer service from team tekin
    Thanks!!!
  • Quote: Using Team Powers 11.5 with RsPro... no problem at all.
    I had the same issue with my TP motor too. Worked fine with my other esc,s not the RS. Other motors worked fine with the RS. It's a sensor sensitivity issue I believe...
  • Quote: I had the same issue with my TP motor too. Worked fine with my other esc,s not the RS. Other motors worked fine with the RS. It's a sensor sensitivity issue I believe...
    What color is the sensor board in your Team Powers motor?
  • Just been informed that the earlier motors didnt have an advanced timing board and didn't support the new gen speedos

    if the end bell is engraved then it will work fine

    cheeRS Phil
  • Quote: Just been informed that the earlier motors didnt have an advanced timing board and didn't support the new gen speedos

    if the end bell is engraved then it will work fine

    cheeRS Phil
    If you Team Powers motor have a green colored circuit board, then it is one of the earlier versions and will not work well with a Tekin. As of January, 2010, all Team Powers motors have the upgraded circuit board andares black in color and we are having great success with these motors when used with a Tekin.


  • here ya go fellas
  • =
    Hi Guys the Early team powers 10.5 and 13.5 do not work with the Tekkin esc. This has now being fixed by TP and you can identify the later motors by the fact the end bell is engraved.

    Phil has kindly posted a picture of my car above..

    I run a team powers on my T3 10.5 Version with NO issues.

    I have also run it with a NOVAK GTB, LRP SPX, LRP Sphere with no issues.
  • Just out of intrest guys what timing and FDR are you guys running with the tekkin and team powers for ..

    Indoor Small Track
    Indoor Large Track

    Any feedback gratefully accepted.
  • Quote: If you Team Powers motor have a green colored circuit board, then it is one of the earlier versions and will not work well with a Tekin. As of January, 2010, all Team Powers motors have the upgraded circuit board andares black in color and we are having great success with these motors when used with a Tekin.
    I've mine with green colour sensor board.

Similar Threads

Tags

v203, vegas 2.0