Yeah i'm going to get the hotwire because this is a tough ESC to adjust. I'm having a hard time locking out reverse!
|
|
I'm having trouble adjusting the throttle curve from mild to aggressive. Can anybody help me out? Will the hotwire also allow me to lockout reverse and change the throttle curve?
|
yes it will.
change the motor type to forward running, and go up on the throttle curve from 3 to 4 or 4 to 5 etc. |
Next weekend I'll be running on a relatively small parking lot track. Technical infield with a 60-70 ft straight. What would be a baseline setup?
Current setup is: HB Moorespeed 6.0fdr Orion 17.5 0deg motor timg Checkpoint 5000 40c Timing boost: 40 Turbo: 15 Ramp: 3 Delay: .5 Start:5442 End: 20,000 Thanks, Rob........ |
Randy, is V206 available yet?
|
Hi
I ran my car on the weekend at a race meet and suffered a motor failure during a run. I thought the motor had just died so i changed it for a new one but now my RS Speedy is now flashing Lights 1,2, 6 and 7. I have looked at the instructions and it say's that this is a motor type selected error but i have it in the right type. So my question is has my speedy died as well when the motor went ? And if so what can i do to get it to go again . Thanks in advance for any help . Brendon |
I have the same car, motor and ESC. Track size 90x45. Mine settings are:
Originally Posted by Robio
(Post 7507596)
Next weekend I'll be running on a relatively small parking lot track. Technical infield with a 60-70 ft straight. What would be a baseline setup?
Current setup is: HB Moorespeed 6.0fdr 8.1 Orion 17.5 0deg motor timg center timing marker Checkpoint 5000 40c TP 5K40C Timing boost: 40 50 Turbo: 15 9 Ramp: 3 3 Delay: .5 .1 Start:5442 1.6K End: 20,000 13K Thanks, Rob........ |
Hi Guys has anyone tried the x12 motor with tekin? what are the best combos people have found 10.5 what motor with the tekin speedo?
Cheers RC |
what is the newest tekin rs firmware avail?
|
203 thats on the website
|
Originally Posted by brendon
(Post 7508450)
Hi
I ran my car on the weekend at a race meet and suffered a motor failure during a run. I thought the motor had just died so i changed it for a new one but now my RS Speedy is now flashing Lights 1,2, 6 and 7. I have looked at the instructions and it say's that this is a motor type selected error but i have it in the right type. So my question is has my speedy died as well when the motor went ? And if so what can i do to get it to go again . Thanks in advance for any help . Brendon mine happened just when i turned it on was fine before on the previous run with the same motor and settings just got ready for a race and it started flashing had to send it back to tekin said it was a short in the internal circuitry was unable to pinpoint the reason and there was no fixing it just sent me new unit contact tekin mate |
Originally Posted by prodriver
(Post 7508768)
Hi Guys has anyone tried the x12 motor with tekin? what are the best combos people have found 10.5 what motor with the tekin speedo?
Cheers RC |
Cheers Mate, what other motors u tried with tekin? what appeared fastest?
CHeers Ricky |
Originally Posted by prodriver
(Post 7509797)
Cheers Mate, what other motors u tried with tekin? what appeared fastest?
CHeers Ricky |
All times are GMT -7. It is currently 07:50 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.